Loading ...
Loading ...
Loading ...
How to Operate Your Ceiling Fan (continued)
16
NOTE: Factory setting is all up. Do not use this
position.
NOTE: The remote unit has 32 different code
combinations. To prevent possible interference
fromor to other remote units, simply change the
combination code in the remote and receiver.
7.
To set the remote code same positions as the
receiver with a small screwdriver or ball point pen
(neither included), slide dip switches firmly up or
down. (Figure 5)
NOTE: If you want to change the blades: turn
Remote
Control
Dip Switch
Figure 5
8. Remote Control Speed (RPM) Setting
Process : (Figure 6)
1) After installing and wiring the unit, restore power to
your fan by ensuring that the breaker and wall switch
that controls the power supply is moved to the on
the battery compartment of the handheld remote control
for 1-3 seconds.
2)
seconds of restoring power to the fan.
3) When restoring power to your fan at the wall switch
and breaker, DO NOT press any button(s) on the
handheld remote control before pressing the “LEARN”
button, otherwise the fan will fail the learn procedure.
4) If you press any button(s) on the handheld remote
control before pressing the “LEARN” button, please turn
the wall switch that controls the power to the fan to the
off position then on again, and start the process
beginning with Step 1 above.
5) When you press the "LEARN" button, the fan will
make one musical sound and light blink once if with
light and start to run beginning the control set up
process.
6) DO NOT press any button(s) after pressing the
LEARN button while the fan is programming or it will fail
to program.
7) The fan will run in forward direction for approximately
3 minutes.
8) When the fan stops running after approximately 3
minutes, the fan will make two musical sounds and light
blink twice if with light that means that the handheld
remote control and speed set up process is complete.
9) The fan is now ready for normal use.
position, press and hold the “LEARN” button inside of
You must press the “LEARN” button within 30
LEARN
Figure 6
5. If you have multiple fans and want to program all
fans to one handheld control. Slide the Dip Switch with
the same position in ALL receiver to ONE handheld to
set up the code for each fans and follow Step 1 of the
remote control speed set up process. Each fan needs
to be no more than 30 feet from the handheld control
that you would like to program. Please note the wall
switch that controls the power to your fan(s) should be
in the off position until you are ready to program your
handheld remote(s).
6. If you have multiple fans and want to program each
fan to separate handheld controls. Slide the Dip
Switch with the same position in both receiver and
handheld to set up the code for each fans and follow
Step 1 of the remote control speed set up process
below for each fans. Repeat these steps for each fan
that you would like to program to a separate handheld
remote. Please note that the wall switch that controls
the power to your fan(s) should be in the off position
until you are ready to program your handheld
Loading ...
Loading ...
Loading ...