Loading ...
Loading ...
Loading ...
7
How to Assemble Your Ceiling Fan
Figure 1
Pin
Set screw
Hanger
Ball
1. Prior to assembly, set aside and save the hardware
bags included in the packaging. Remove the hanger
ball by loosening the set screw in the hanger ball until
the ball falls freely down the downrod. Remove the pin
from the downrod, then remove the hanger ball.
Retain the pin and hanger ball for reinstallation in
Step 6. (Figure1)
2. Remove the hairpin clip and clevis pin from the
bottom of downrod. Retain the pin and clip for
reinstallation in Step 4. (Figure 2)
Figure 2
Downrod Support
Figure 3
Set Screws
and Nuts (2)
4. Slide downrod into the downrod support on top of
the motor. Install the clevis pin by aligning the holes
in the downrod support with holes in the downrod.
Secure clevis pin with hairpin clip. Install the two
set screws with nuts in the downrod support. Securely
tighten the set screws with screwdriver then fully
tighten the nuts using the hex wrench. (Figure 4)
WARNING
Hairpin Clip
Clevis Pin
It is critical that the clevis pin in the downrod
support is properly installed and the set screws
and nuts are securely tightened. Failure to do
so could result in the fan falling.
Hairpin Clip
Set Screws
and Nuts (2)
Downrod
Clevis Pin
3. Loosen the two set screws and locking nuts in
the downrod support of the motor assembly. Route
brown, blue, red, gray, yellow wires and safety
cable through the downrod. (Figure 3)
Brown, Blue, Red,
Gray, Yellow wires
and Safety Cable
Figure 4
Loading ...
Loading ...
Loading ...