Loading ...
Loading ...
Loading ...
Regulatory notices
The printer meets product requirements from regulatory agencies in your country/region.
This section contains the following topics:
●
Regulatory model number
●
FCC statement
●
Power cord instructions
●
Notice to users in Korea
●
VCCI (Class B) compliance statement for users in Japan
●
Notice to users in Japan about the power cord
●
Noise emission statement for Germany
●
European Union and United Kingdom Regulatory Notice
●
Products with wireless functionality
●
Visual display workplaces statement for Germany
●
Regulatory wireless statements
Regulatory model number
For regulatory identication purposes, your product is assigned with a Regulatory Model Number. The
regulatory model number should not be confused with the marketing names or product numbers.
FCC statement
The United States Federal Communications Commission (in 47 CFR 15.105) has specied that the following
notice be brought to the attention of users of this product.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment o and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and the receiver.
● Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
● Consult the dealer or an experienced radio/TV technician for help.
NOTE: If the product has an Ethernet / LAN port with metallic casing then use of a shielded interface cable is
required to comply with the Class B limits of Part 15 of FCC rules.
ENWW Regulatory notices 103
Loading ...
Loading ...
Loading ...