Vevor M1H-ZP5-254D-1 User Manual

Loading ...

c) Immediately reattach the guarding system after completing an operation (such as

rabbeting, dadoing or resawing cuts) that requires the removal of the guard, riving

knife and/or anti-kickback device. The guard, riving knife, and anti-kickback device

help to reduce the risk of inju.

d) Make sure the saw blade is not contacting the guard, riving knife or the work-

piece before the switch is turned on. Inadveent contact of these items with the saw

blade could cause a hazardous condition.

e) Adjust the riving knife as described in this instruction manual. Incorrect spacing,

positioning and alignment can make the riving knife ineective in reducing the

likelihood of kickback.

f) For the riving knife and anti-kickback device to work, they must be engaged in the

workpiece. The riving knife and anti-kickback device are ineective when cutting

workpieces that are too sho to be engaged with the riving knife and anti-kickback

device. Under these conditions, a kickback cannot be prevented by the riving knife

and antikickback device.

g) Use the appropriate saw blade for the riving knife. For the riving knife to function

properly, the saw blade diameter must match the appropriate riving knife and the

body of the saw blade must be thinner than the thickness of the riving knife and the

cutting width of the saw blade must be wider than the thickness of the riving knife.

2) Cutting procedures warnings

a) DANGER: Never place your ngers or hands in the vicinity or in line with

the saw blade. A moment of inattention or a slip could direct your hand toward the

saw blade and result in serious personal inju.

b) Feed the workpiece into the saw blade or cutter only against the direction of

rotation. Feeding the workpiece in the same direction that the saw blade is rotating

above the table may result in the workpiece, and your hand, being pulled into the

saw blade.

c) Never use the mitre gauge to feed the workpiece when ripping and do not use the

rip fence as a length stop when cross cutting with the mitre gauge. Guiding the

workpiece with the rip fence and the mitre gauge at the same time increases the

likelihood of saw blade binding and kickback.

d) When ripping, always apply the workpiece feeding force between the fence and

the saw blade. Use a push stick when the distance between the fence and the saw

blade is less than 150 mm, and use a push block when this distance is less than 50

mm. “Work helping” devices will keep your hand at a safe distance from the saw

blade.

Loading ...

Vevor M1H-ZP5-254D-1 10" Table Saw w/ Stand Electric Cutting Machine 5000RPM 25-in Rip Capacity