Loading ...
Loading ...
Loading ...
25
2. RESET BUTTON (OVERLOAD PROTECTOR)
This saw comes with an overload reset button (B) If the saw motor over heats, a
safety mechanism stops the motor automatically due to motor over-heating or low
voltage. To prevent motor over-heating, reduce load on motor or check
voltage.
Allow motor to cool down, then press the reset button and resta the saw. If the saw
does not resta, wait an additional 5 minutes before restaing.
Cross cutting
Cross cutting requires the use of the miter gauge to position and guide the work.
Place the work against the miter gauge and advance both the miter gauge and work
toward the saw blade. The miter gauge may be used in either table T-slot, however,
most operators prefer the left groove for average work. When bevel cutting (blade
tilted), use the right side table T-slot so that it doesn’t inteere with the tilted saw
blade. The blade guard must be used. The riving knife to prevent the saw ke from
closing.
Sta the cut slowly and hold the work rmly against the miter gauge and the table.
One of the rules in running a saw is that you never hang onto or touch a free piece
of work. Hold the suppoed piece, not the free piece that is cut o. The feed in cross
cutting continues until the work is cut in two, then the miter gauge and work are
pulled back to the staing point. Before pulling the work back it is good practice
to give the work a little sideways shift to move the work slightly away from the saw
blade. Never pick up any sho length of free work from the table while the saw is
running. A sma operator never touches a cut-o piece unless it is at least a foot
long. Never use the rip fence as a cut-o gauge when cross cutting.
Ripping
Ripping is the operation of making a length wise cut through a board, the rip fence
is used to position and guide the work. One edge of the work rides against the rip
fence while the at side of the board rest on the table. Since the work is pushed
along the fence, it must have a straight edge and make solid contact with the table.
The blade guard must be used. The guard has anti-kickback ngers and a riving
knife to prevent the saw ke from closing.
Loading ...
Loading ...
Loading ...