Loading ...
Loading ...
Loading ...
MIC
Microphones or other low level equipment can be
connected to this input.
LINE
The Line Input can be selected in place of the
Microphone Input. This input is designed for
higher, line level signals.
TAPE/DAW INPUTS
The output of your converters/tape machine
should be connected here. This input is designed
for line level signals.
SEND / RET
There are two insert points per channel, with the
Tape/DAW Insert on the left and the Mic/Line
Insert on the right.
The Insert Points are half-normalled so the sends
can be used as extra outputs without breaking the
signal path. Plugging a jack into the return breaks
the signal path so be careful not to plug a jack in
without a piece of gear attached.
Please note that the insert points aren’t affected
by the Flip Switch.
NOTICE
Please note that if you have the Patchbay module tted,
the rear Connector Panel will only have the Mic and Line
Inputs; the inserts and Tape/Daw Returns can be accessed
via the patchbay module.
For more information, please see the Patchbay Section
of this manual.
The rear mounted Connector Panel is where the
input, output and insert point connectors are
located.
The Microphone Input uses an XLR Connector,
while the Line Input, Tape Input and the Insert
Sends and Returns use Tip, Ring and Sleeve jacks.
1
2
3
4
1
3
4
2
28
connector panels
Loading ...
Loading ...
Loading ...