Loading ...
Loading ...
Loading ...
WARNING: Always use protective
gloves when you assemble the product.
1. Examine the flange washers and the spindle shaft.
Refer to
To examine the spindle shaft and the flange
washers on page 14
.
2. Push back and hold the SmartGuard in the retracted
position.
Note: This step only applies to K 1270
SmartGuard.
3. Put the cutting blade on the arbor bushing (A)
between the inner flange washer (B) and the flange
washer (C). Turn the flange washer until it holds on
to the shaft.
A
B
C
4. Put a tool into the hole in the front belt guard and
turn the cutting blade until the shaft is locked.
5. Tighten the cutting blade bolt to 25 Nm/18.5 ft-lb.
To reverse the cutting head (K 1270 II)
WARNING: Only cut with the cutting
head reversed if a standard procedure is not
possible.
The product has a reversible cutting head that lets you
cut near a wall or at ground level. Only cut with the
cutting head reversed if a standard procedure is not
possible. If a kickback occurs, it is more difficult to
control the product if the cutting head is reversed. The
distance between the cutting blade and the center of the
product is longer, which means that the handle and the
cutting blade do not align. This has a negative effect on
the balance in the product and it is more difficult to hold
the product if the cutting blade is pinched or stalled in
the kickback zone. Refer to
Kickback on page 16
.
WARNING: Make sure that the engine
is off and that the stop switch is in the STOP
position.
WARNING: Always use protective
gloves when you assemble the product.
1. Remove the cutting blade, the front belt cover and
the cutting head. Refer to steps 1-5 in
To replace the
drive belt on page 29
.
2. Remove the 2 screws and nuts that hold the spray
nozzle.
1631 - 001 - 04.05.2021
15
Loading ...
Loading ...
Loading ...