Loading ...
Loading ...
Loading ...
5. Use (B) and (D) to change the target time
hour setting.
Hours
6. Press (C).
7. Use (B) and (D) to change the target time
minute setting.
Minutes
8. Press (C).
9. Use (B) and (D) to change the target time
second setting.
Seconds
●
If you want to specify multiple target
times, repeat steps 2 through 9 above.
10. Press (A) to exit the setting screen.
Measuring Elapsed Time with the
Target Time Function
You can perform the same elapsed time
operations as those described in the sections
below.
l
Measuring Elapsed Time
l
Measuring a Split Time
l
Measuring Lap Times
Starting an elapsed time operation will cause
[TGT] to flash on the display.
An alarm will sound for 10 seconds to let you
know when the elapsed time operation
reaches a target time you set.
[TGT] disappears from the display when the
elapsed time operation exceeds the last target
time.
D
Stop *
Target time reached.
Start
Reset
* [TGT] is displayed if you stop the elapsed
time measurement operation before the target
time was reached.
Clearing Target Times
The procedure below restores target time
settings to their initial factory defaults.
●
Target Time 1: 5 minutes
●
Target Time Function: Off
1. Hold down (A) for about two seconds.
2. Hold down (B) and (D) at the same time
for about five seconds until [ALL] stops
flashing on the display.
This restores target time settings to their
initial factory defaults.
3. Press (A) to complete the operation.
Viewing Measured Time Data
Viewing Data Records
You can use the operation below to view split
times and lap times.
1. Enter the Recall Mode.
l
Navigating Between Modes
●
This causes the record number of the
latest measurement to appear.
Record number
Operation Guide 5554/5555
13
Loading ...
Loading ...
Loading ...