Loading ...
Loading ...
Loading ...
MOUNTING BOLTS
BELT AND DISC SANDER
Securely clamp board to workbench using "C"
clamps.
SPECIAL NOTE: The supporting surface where
belt and disc sander is mounted should be examined
carefully after mounting is complete to insure that
no movement during use can occur, tf any tipping
or walking is noted, secure workbench or supporting
surface before operating belt and disc sander.
MOUNTING BDARO
WORKBENCH
C'CLAMP
INSTALLING TIMING BELT
IMPORTANT -- Do not overtighten timing belt tension
by adjusting timing setscrew too tight, This is a COG
Belt which does not require excessive tension to func-
tion properly.
1, Locate the two locking bolts holding the sanding belt
table and loosen both with a 1!2 inch wrench.
WRENCH
BE; _
TABLE
i
TABLE
LOCKING BO[TS
,ii! i! , iiii !l i Ul H 'IUlIIIII II IIII
2. Raise the sanding belt table to the vertical position.
3. On top of the base locate the timing setscrew cen-
tered in the Iocknut. Loosen the Iocknut with a 7/16
inch wrench and raise the setscrew about 1/4 inch
using the 1/8 inch hex wrench,
TIMING BELT
TENSION
ADJUSTMEr'_TSET
SCREW AND
LOCK1NGNUT
Loading ...
Loading ...
Loading ...