Loading ...
Loading ...
Loading ...
bolt
among loose _arts.
insert rod in base as shown, leaving 5 inches of rod
extending outside base,
BASE
ROD
3. Install bolt in base (align a flat side of rod to bolt)
and tighten with 1/2 inch wrench.
......... i
I I I II
4. Slide table assembly onto rod.
WARNING: To avoid trapping the work or fingers
between the table and sanding surface, the table
edge should be a maximum of 1/16-inch from sand-
ing surface. Table assembly should be completely
engaged on rod.
5. The table must be adjusted so it is parallel to the
sanding surface and no further away from the sand-
ing surface than 1/16".
6. To adjust the 1/16" gap, slide the table assembly
forward on the rod and tighten the table assembly
lock knob.
12
\
ROD
TABLEASSEMBLY
\
TABLEASSEMBkY
LOCKKNOB
Loading ...
Loading ...
Loading ...