Loading ...
Loading ...
Loading ...
Preparing to Play
7
Preparing to Play
Using the AC adapter
1.
Make sure that the power on this instrument is turned o.
2.
Connect the DC plug of the included AC adapter to the
DC 12V jack located on the rear panel of the EK‑50.
Be sure to use only the included AC adapter. Using any
other AC adapter may cause malfunctions.
Hook the AC adapter cord onto the cord hook. Do not use
excessive force when pulling the cord o the hook.
Cord hook
AC adapter (included)
When hooking the cord onto
the cord hook, be careful not
to bend this part any more
than necessary.
3.
Connect the plug of the AC adapter to an AC outlet.
Be sure to use an AC outlet of the correct voltage for
your adapter.
Using this instrument with batteries
You can use eight AA alkaline or nickel‑metal hydride baeries
to power this instrument.
Zinc‑carbon baeries cannot be used.
Note:
Baeries are not included, so please obtain them
separately.
Installing batteries
1.
Make sure that the power on this instrument is turned o.
2.
Push the two tabs on the baery compartment cover that is
located on the boom of this instrument to open the cover.
Note:
When turning the
instrument upside down,
place it on a blanket or similar
material to prevent damage to
the display, joystick and so on.
3.
When inserting the baeries,
be sure to observe the correct polarity (“+” and “–”).
Do not mix new and old
baeries, or baeries of dierent
types. Failing to observe this
guideline might cause the
baeries to leak or burst.
4.
Close the baery cover.
Note:
To make sure the correct
baery level is displayed, make the seing on this instrument
for the type of baery you are using (see page 21 “Seing the
baery type”).
Replacing the batteries
The baery indicator is displayed at the top right‑hand part of
the display.
Note:
This indicator will not be displayed while the AC adapter
is plugged in.
When the indicator is blinking, this means that the baeries are
nearly depleted, so replace the baeries as soon as possible or
connect an AC adapter to power this instrument.
Remove depleted baeries immediately. Leaving depleted
baeries in could result in malfunctions caused by baery
electrolyte leakage or similar problems. Also, remove the
baeries if you will not be using the EK‑50 for a long time.
Turning the power on/o
1.
Turn the VOLUME knob all the way to the left, so that the
volume is down.
2.
Press the power buon to turn the instrument on.
When turning o the power, hold the power buon down
until the backlight on the display goes dark.
Note:
The EK‑50 will automatically turn o if it has not been
played or operated for a certain amount of time (via the auto
power‑o function).
The time interval is set to 30 minutes at factory default. This
interval can be changed (see page 21 “Changing the auto
power‑o function”).
1
2
Loading ...
Loading ...
Loading ...