Loading ...
Loading ...
Loading ...
10
BLOWER ACTIVATION/SPEED LEVEL CHANGE/FILTER INDICATOR RESET
When blowers are OFF, press on this push button to turn ON the blowers at the last saved speed. If there was no speed saved, the blowers
will be set on LOW speed.
NOTE: When LOW speed is activated from OFF, the blowers start on MEDIUM speed for a very short lapse of time, and then resume to
LOW speed.
To change the blower speed, press this button again until the desired speed is reached (from LOW to MEDIUM to HIGH speed to OFF).
Each time a blower speed is activated, a rotating blower icon appears on left side of LCD screen, with dot(s) under it (slow for LOW with
one dot, faster for MEDIUM with 2 dots and fastest for HIGH with 3 dots).
When blowers are on (no matter the speed level), press and hold this button until the blower icon disappears from the LCD screen; this will
turn off the blowers and save the blower speed chosen.
Heat Sentry™
This hood is equipped with a protective device that activates the blowers when an abnormally high heat level is detected while the blowers
are activated. During the Heat Sentry activation, this device takes control of the blowers and set them on MEDIUM speed while all dots
under the blower icon blink. However, the lights can be still controlled. The blowers will remain on MEDIUM speed until the heat is back to
normal, they then return to the speed previously selected.
NOTE: When excessive heat is detected, Heat Sentry will shut off both blowers and lights while all dots under the blower icon will blink
faster. Both blowers and lights will remain off until the ambient temperature cools down; the blowers will then start on MEDIUM
speed (the lights can be controlled again). The blowers will remain on MEDIUM speed until the heat is back to normal, they then
return to the speed previously selected.
FILTER CLEANING REMINDER
This icon appears on LCD screen 30 seconds after turning OFF the blowers when it is time to clean hood and filters. This happens every
time the blowers are turned OFF until the filter cleaning reminder has been reset. Once the cleaning is done, reset the filter cleaning
reminder by pressing on blower activation push button for 3 seconds while the icon appears on LCD screen for 30 seconds.
ON LIGHTING/LIGHT INTENSITY CHANGE
Press this button to turn on the lights at the last saved intensity; the light icon appears on right side of LCD screen and the number of dots
below it shows which light intensity is on (one dot for LOW, two dots for MEDIUM and three dots for HIGH).
To change the light intensity, press button until the desired level is reached (from HIGH intensity, pressing again will shut off the lights).
When lights are on (no matter the light intensity), press and hold this button until the light icon disappears from the LCD screen; this will
shut off the lights and save the chosen light intensity.
MASTER ON/OFF
Press this button to turn on the ligths and the blowers at the last saved intensity. When either lights or blowers are ON, pressing this button
will memorize the current blower speed and lighting level prior to shut them OFF.
DELAY OFF
When the blowers are on, press this button to activate the delay function. This icon appears on LCD screen beside the blower icon to
indicate the function is on. The blowers will continue to operate for 10 minutes and then, will shut off automatically (both blower and delay
icons will disappear from LCD screen). When Delay off is activated, it is possible to change the blower speed by pressing on blower push
button without affecting the remaining time of the delay.
To cancel the delay off function before the end of the 10-minute cycle, press this button again.
18. OPERATION
Operation
Always turn your hood on before you begin cooking to establish an air flow in the kitchen.
Let the blower run for a few minutes to clear the air after you turn off the range. This will help keep the whole kitchen cleaner and
fresher. Operate the hood as follows:
NOTE: At range hood start-up or after a power failure, a small icon (1) appears shortly (for ± 2 seconds) on LCD screen; this is normal.
1
Loading ...
Loading ...
Loading ...