Loading ...
I kWARNING
• ALL RANGES CAN TIP
• INJURY TO PERSONS
COULD RESULT
• INSTALL ANTI-TIP
DEVICE PACKED
WITH RANGE
• SEE INSTALLATION
INSTRUCTIONS
STABILITY DEVICE INSTALLATION INSTRUCTIONS
FOR BRACKET KIT NO. 342473
TOOLS NEEDED:
Phillips head screwdriver
1 _8" open end or adjustable wrench
Bracket attaches to floororwallto hold either right or left
rear leg leveler. Iffastening to floor, be sure that screws
do not penetrate electrical wiring or plumbing. If this
cannot be determined, use shorter screws that will not
penetrate through flooring.
Ifthe bracket came with your range, it Is shipped In the
prepack located Inside the oven. Remove the bracket
from the prepack and follow the instructions below.
.
1. Decide whether the bracket will be Installed on the
right or left side of range location.
2. If the bracket side of the range Is adjacent to a
cabinet, place the bracket against back wall and
cabinet as shown in Figure 1.
If there Is no adjacent cabinet, determine where the
location of the range side (painted outside panel) will
be. Place the bracket with Its outside edge at this
location and against back wall. See Figure 1.
4,
.
Determine whether you will anchorthe bracket to the
floor or wall. Fasten the bracket securely with the
screws provided. Screws are self-drilling in wood,
plywood, particle and chip board, and most metal
framing. Ifattaching to masonry, you can buy suitable
screws and anchors at hardware stores. Use a
masonry drill to drill the required holes.
Using the wrench, back out the four leg levelers at
least two turns. See your Installation guide for more
leveling Information before positioning range.
Slide the range Into place. Be sure rear leg leveler
fully engages slot in bracket. If range cannot be
moved back far enough for rear leg leveler to enter
bracket, move bracket forward as required and attach
to floor In new location.
ADJACENT CABINET OR FINNALI
LOCATION OF RANGE SIDE
PANEL
OUTSIDE EDGE OF
BRACKET TO BE
FLUSH WiTH LEFT OR
RIGHT SIDE OF RANGE
\
WALL BEHIND
BRACKET
SCREWMUSTENTER
WOODOR METAL |
WALL
PLATE
/
A'FFACHMENTTOWALL
Fig. 1 Fig. 2
1 NCINSOt-3
Loading ...
Loading ...
Loading ...