Loading ...
Loading ...
Loading ...
Note: Your vehicle could have side steps
that can become damaged, due to reduced
ground clearance, when taking your vehicle
off-road. Remove side steps before driving
your vehicle off-road.
SELECTING A FOUR-WHEEL DRIVE
MODE
To select a specific four-wheel drive mode
please select one of the desired drive
modes. For additional information. See
Selecting a Drive Mode (page 295).
Note: When shifting to and from four-wheel
drive, a message appears in the instrument
cluster display indicating that the system is
in the process of making a shift.
Note: Do not perform this operation if the
rear wheels are slipping or while applying
the accelerator pedal.
If the system detects a fault, a warning
message appears in the instrument cluster
display. See Four-Wheel Drive –
Information Messages (page 228).
Note: Do not use DEEP CONDITIONS or
SLOW CLIMB on dry, hard surfaced roads.
Doing so produces excessive noise,
increases tire wear and may damage drive
components. The 4X4 system in these
modes is only intended for consistently
slippery or loose surfaces.
Shifting to or from Slow Climb (4L)
To select or exit SLOW CLIMB (4L):
1. Bring your vehicle to a speed of 3 mph
(5 km/h) or less.
2. Place the transmission in neutral (N).
3. Select SLOW CLIMB on the drive mode
switch.
A message appears in the instrument cluster
display indicating a four-wheel drive shift is
in progress. If any of the above shift
conditions are not present, the shift will not
occur and a message appears in the
instrument cluster display guiding you
through the proper shifting procedures. If
there is a transfer case tooth blockage, a
message appears in the instrument cluster
display. To alleviate this condition, place the
transmission in a forward gear, move your
vehicle forward approximately 4.9 ft (1.5 m),
and shift the transmission back to neutral (N)
to allow the transfer case to complete the
range shift.
Note: You could hear some noise as the
system shifts or engages which is normal. If
the system detects a fault, a warning
message appears in the instrument cluster
display. See Four-Wheel Drive –
Information Messages (page 228).
FOUR-WHEEL DRIVE MODES
TWO-WHEEL DRIVE HIGH
2H turns on when you select NORMAL or
CONSERVE. Two-wheel drive high is for
general on-road driving. Power is sent to the
rear wheels only.
Note: Two-wheel drive high can turn on or
off based on Drive Mode selection See Drive
Mode Control (page 294).
226
2024 Navigator (TB9) Canada/United States of America, enUSA, Edition date: 202306, DOM
Four-Wheel Drive (If Equipped)
Loading ...
Loading ...
Loading ...