Brickhouse Security LYSB019OWIAXS-ELECTRNCS User Manual

Loading ...

manufacturers, best placement will vary by vehicle. If signal strength seems

to be weak, move the device to a dierent position and check the platform

to see if the device has connected and is reporting.

Once the unit has been installed, take the car for a drive for 15-20 minutes

so the device can register on the GPS network and begin reporting. The

Livewire 4 is motion activated; it will only attempt to communicate with the

platform when motion is detected, which will update the tracker’s position

on the map.

The Red and Green LEDs on the label side of the device are intended to

help you troubleshoot problems with your tracker. When the car’s ignition is

rst turned on, the device will power up. The GPS Light (RED) should begin

to ash followed by the Cell Light (GREEN). The GPS Light will turn solid

once a GPS signal is located. The Cell Light will slow down, but remain

ashing once it has connected to the cellular network.

The Red and Green LEDs on the back panel of the device are intended to

help you troubleshoot problems with your Livewire. When the car’s ignition

is rst turned on, the device will power up. The Green LED will show solid

for approximately 30 seconds (there may be some brief ickers initially

Loading ...

Brickhouse Security LYSB019OWIAXS-ELECTRNCS LTE Livewire 4 Vehicle GPS Tracking Device For Cars, Trucks, Teens, Fleets, With No Batteries Required - Subscription Required!