Loading ...
Loading ...
Loading ...
11
NOTE:
This appliance must be grounded / earthed.
Fixed wiring installations must incorporate an all-pole disconnection switch.
9. Correctly locate the appliance into its final operating position and using a spirit level, adjust the legs
so that the appliance is level and at the correct height.
10. Connect the power supply to the appliance.
11. Check that the electrical supply is as shown in 'Specifications' section of this manual.
NOTE:
The water supply must be protected by an 'In-Line' sediment filter / strainer, which
should be fitted into the pipeline prior to the Bratt Pan water connection.
All water pipework must be thoroughly flushed prior to completion of the installation
procedure.
Cold water mains ¾” BSP male thread connection point. For location details on services connections refer
to the drawings in the ‘Specification’ section.
Maximum water supply pressure - 550kPa (80 psi).
Maximum Water Supply Temperature - 80°C.
Remove the control panel for access to the cold water connection.
1. Before leaving the new installation;
a. Check the following functions in accordance with the operating instructions specified in the
‘Operation’ section of this manual.
Ensure that all water pipework has been thoroughly flushed through prior to using the
appliance.
Check the current draw and loading for the equipment. Refer specification section for
correct electrical requirements.
Check that all the connections are correct and that all cover panels have been re-fitted.
Check that the appliance functions in accordance with the operating instructions.
Ensure that this instruction manual is left with the appliance.
Ensure that all the relevant details and contacts have been added to the front of this
manual.
b. Ensure that the operator has been instructed in the areas of correct operation and shutdown
procedure for the appliance.
2. This manual must be kept by the owner for future reference and as a record of
Date of Purchase,
Date of Installation
and
Serial Number of the Unit
recorded and kept w ith this manual.
(These details can be found on the Rating Plate attached to the bottom corner of the
front right hand sill panel. Refer to the ‘Electrical Connection’ section).
NOTE:
If for some reason it is not possible to get the appliance to operate correctly, turn off
the electrical power supply and contact a qualified service person. The supplier of
this appliance will be able to recommend a suitable person.
Make sure that the electrical supply is turned off before any service or maintenance
work is carried out.
Loading ...
Loading ...
Loading ...