Loading ...
Loading ...
Loading ...
9
NOTE:
It is most important that this appliance is installed correctly and that operation is
correct before use. Installation shall comply with local electrical and health and
safety requirements.
This appliance shall be installed with sufficient ventilation to prevent the occurrence
of unacceptable concentrations of health harmful substances in the room, the
appliance is installed in.
Waldorf Bratt Pans are designed to provide years of satisfactory service and correct installation is essential
to achieve the best performance, efficiency and trouble-free operation.
This appliance must be installed in accordance with National installation codes and in addition, in
accordance with relevant National / Local codes covering electrical, fire and health and safety.
Australia / New Zealand: AS / NZS 3000 - Wiring Rules.
AS / NZS 3500 - Plumbing and Drainage.
United Kingdom: BS 7671 - Requirements for Electrical Installations.
Installations must be carried out by authorised persons only. Failure to install equipment to
the relevant codes and manufacturer’s specifications shown in this section will void the
warranty.
Components having adjustments protected (e.g. paint sealed) by the manufacturer are only to
be adjusted by an authorised service agent. They are not to be adjusted by the installation
person.
1. Remove all packaging and transit protection from the appliance including all protective plastic coating
from the exterior stainless steel panels.
2. Check equipment and parts for damage. Report any damage immediately to the carrier and
distributor.
3. Report any deficiencies to the distributor who supplied the appliance.
4. Check that the available electrical supply is correct to that shown on the rating plate located on the
bottom right hand corner of the bottom sill.
1. Any appliance requires adequate clearance and ventilation for optimum and trouble-free operation.
The following minimum installation clearances are to be adhered to:
2. Never directly connect a ventilation system to the appliance flue outlet.
3. Installation must include adequate ventilation means, to prevent dangerous build up of combustion
products.
4. Position the Bratt Pan in its approximate working position.
5. The legs must always be fitted to the unit.
NOTE: Do not block or obstruct the appliance flue.
NOTE: Only non-combustible materials can be used in close proximity to this appliance.
(*) Side clearances can be 50mm when the adjacent surface is at least 100mm below the cooking
surface.
Left / Right Hand Side (*) 50mm 0mm
Rear 50mm 0mm
Loading ...
Loading ...
Loading ...