Loading ...
Loading ...
Loading ...
Operating Instructions
STEPS TIPS IMPORTANT
4. Turn on the
Power and
select the
appropriate
cycle and
settings for
each load.
• See
Cycle Selection
and
Cycle Settings
for detailed
descriptions of cycle controls.
• See
Cycle Settings Chart
to determine which set-
tings are available for each cycle.
• To provide the best care, not every setting or op-
tion is available with every cycle. If a setting or op-
tion is not available for the cycle selected, the indi-
cator will not light. See
Setting Chart
for information
of available options for each cycle by model.
• After some time of initial usage, the dryer will
automatically remember the 3 most used cycles
with their settings and options.
DO NOT over-dry.
Over-drying can
cause wrinkles,
shrinkage, lint, and
a build up of static
electricity.
5. Close the
dryer door
and start
the drying
cycle.
• To start the drying cycle, close the door and press
the Start/Pause button.
• To add an item to the dryer drum, press Start/
Pause. “PAUSE” will be displayed alternately with
the estimated remaining cycle time. Opening the
door with a cycle running will also pause the cycle.
Add the item, close the door and press Start/
Pause again to resume the cycle.
• To change settings or options after the cycle has be-
gun, press Start/Pause, change the settings, and
then press Start/Pause again. If the cycle is not
paused first, the unit will emit several beeps when
the buttons are pressed but no changes to the cycle
will be applied.
• To change the cycle once the cycle has begun,
press the Power button to turn off the unit and
cancel the cycle. Press the Power button again to
turn on the unit and select the new cycle, and press
Start/Pause to begin. Changing a cycle selection
without cancelling the current WILL NOT change
the cycle.
• To cancel a cycle, press the Power button to turn
off the unit.
When drying a single
large or bulky item,
such as a comforter,
pause the cycle part
way through to turn
the item “inside out”
and maximize drying
effectiveness.
6. Remove
items when
done.
• A signal will sound at the end of the cycle if the
chime option has been selected.
• Immediately remove items when the cycle is
completed and hang or fold.
7. Clean the
lint filter and
the water
container.
• See
Care and Cleaning
section of this instruction.
• CLEAN LINT will be displayed at the end of the
cycle as a reminder to remove lint from filter.
ALWAYS CLEAN
LINT FROM FILTER
and DRAIN WATER
CONTAINER at
the end of each
cycle (see warning
on previous page).
8
Loading ...
Loading ...
Loading ...