Loading ...
Loading ...
Loading ...
CAUTION: The stop switch
automatically goes back to run position.
To operate the product
• Start near the ground and move the product up
along the hedge when you cut the sides.
• Adjust the speed to align with the work load.
• Make sure that the engine does not touch the hedge.
• Hold the product near your body for a stable work
position.
• Make sure that the tip of the cutting equipment does
not touch the ground.
• Be careful and work slowly until all the branches are
correctly cut.
Maintenance
Introduction
WARNING: Read and understand the
safety chapter before you do maintenance
on the product.
Maintenance schedule
Maintenance Before
operation
After 40
h
After 100
h
Clean the external surface. After each operation.
Clean the muffler, exhaust pipe and engine from leaves, dirt and unwanted
lubricant.
After each operation.
Make sure that the cutting unit does not move at idle speed. X
Do a check of the stop switch. Refer to
To do a check of the stop switch on page
6
.
X
Examine the cutting unit for damages and cracks. Replace if it is damaged. X
Examine the hand guard for damages and cracks. Replace if it is damaged. X
Do a check of the throttle trigger lockout and the throttle trigger. Refer to
To do a
check of the throttle trigger lockout on page 5
.
X
Examine the engine, the fuel tank and the fuel hose for leaks. X
Tighten nuts and screws. X
Examine the starter and the starter rope for damages. X
Do a check that the screws that hold the blades together are correctly tightened. X
Clean the air filter. Clean more frequently if used in areas which has dust.
Replace if it is damaged.
X
1118 - 005 - 29.08.2023 11
Loading ...
Loading ...
Loading ...