Loading ...
Loading ...
Loading ...
14
EN
Connecting Hose to Water Tap
Connecting Screw-Type Hose to
Tap with Thread
Screw the hose connector onto the water supply
tap.
Connecting Screw-Type Hose to
Tap Without Thread
1
Loose the four fixing screws.
Upper
connector
Rubber seal
Fixing screw
2
Remove the guide plate if the tap is too
large to fit the adapter.
Guide plate
3
Push the adapter onto the end of the tap so
that the rubber seal forms a watertight
connection. Tighten the four fixing screws.
4
Push the supply hose vertically upwards so
that the rubber seal within the hose can adhere
completely to the tap and then tighten it by
screwing it to the right.
Plate
Supply
hose
Connecting One Touch Type Hose
to Tap Without Thread
1
Unscrew the adapter ring plate and loose the
four fixing screws.
Ring plate
2
Remove the guide plate if the tap is too large
to fit the adapter.
Guide plate
3
Push the adapter onto the end of the tap so
that the rubber seal forms a watertight connection.
Tighten the four fixing screws and the adapter
ring plate.
4
Pull the connector latch plate down, push the
supply hose onto the adapter, and release the
connector latch plate. Make sure the adapter
locks into place.
NOTE
•
Before connecting the supply hose to the water
tap, turn on the water tap to flush out foreign
substances (dirt, sand, sawdust, and etc.) in the
water lines. Let the water drain into a bucket, and
check the water temperature.
Latch
plate
Loading ...
Loading ...
Loading ...