Loading ...
Loading ...
Loading ...
Page 11
1. Disconnect the plug from the power
supply.
2. Place the xed base on a at surface.
3. With the back of xed base facing you,
open the motor clamp.
4. Press in the coarse-adjustment button
while you align the coarse-adjustment
notches on the motor with the slot in the
xed base.
5. Slide the motor down into the xed base.
6. The router motor will now slide up or
down to set adjustments when the
coarse-adjustment button is pressed in.
7. After all adjustments are made, close
the router clamp securely.
FIG. 4
Slot
Coarse-
adjustment
button
Coarse- adjustment
notches
Motor
clamp
REMOVING MOTOR FROM THE
FIXED BASE (FIG. 4)
1. Disconnect the plug from the power
supply.
2. Place the router on a at surface.
3. With the back of the router facing you,
open the router motor clamp.
4. Push in the coarse-adjustment button
while you lift router motor out of the
xed base.
5. Set the motor upside down on its top
cap with the collet pointing up and
remove cutter bit.
INSTALLING THE
DUST-EXTRACTION
ADAPTOR (FIG. 5)
To attach the dust-extraction adaptor onto
the xed base, position and secure it to the
base with the screws (included) as shown in
FIG. 5.
FIG. 5
Dust-extraction
adaptor
Fixed base
ADJUSTING THE DEPTH OF CUT
WARNING:
Your router should
never be turned on or be connected to the
power source when you are assembling
parts, making adjustments, installing
or removing collets/nuts and cutter
bits, cleaning or when it is not in use.
Disconnecting the router will prevent
accidental starting, which could cause
serious personal injury.
DEPTH ADJUSTMENT WITH
FIXED BASE (FIG. 6)
NOTICE: All depth adjustments on the
xed base must be made with the motor
clamp open.
NOTICE: For all xed base routers, the
cutter bit depth equals the amount of the
cutter that is exposed below the surface
of the sub-base.
ASSEMBLY
Loading ...
Loading ...
Loading ...