Loading ...
Loading ...
follow them. If you cannot find the oper‐
ating instructions, you can download the
operating instructions from the internet by
entering the service number at
home.liebherr.com/fridge-manuals. The
service number can be found on the serial
tag:
-
Observe the warning messages and other
detailed information in the other sections
when installing the appliance:
DANGER
indicates a hazardous situa‐
tion, which if not avoided, will
result in death or serious
injury.
WARNING indicates a hazardous situa‐
tion, which if not avoided,
could result in death or serious
injury.
CAUTION indicates a hazardous situa‐
tion, which if not avoided, will
result in minor or moderate
injury.
NOTICE indicates a hazardous situa‐
tion, which if not avoided,
could result in damage to prop‐
erty.
Note indicates useful advice and
tips.
2 Setup conditions
WARNING
Risk of fire due to moisture!
If live parts or the power cord get wet, this can cause a
short circuit.
u
The appliance is designed for use in enclosed
spaces. Do not operate the appliance in open space
or in damp areas or where there is spray.
Normal use
-
Only set up and use the appliance in enclosed
spaces.
2.1 Space
WARNING
Leaking refrigerant and oil!
Fire. The refrigerant contained within the appliance is
environmentally friendly, but flammable. The oil
contained within the appliance is flammable. Escaping
refrigerant and oil can ignite if they are of high enough
concentration and are exposed to an external heat
source.
u
Do not damage the pipelines of the coolant circuit
and the compressor.
-
If the appliance is installed in a very damp environ‐
ment condensate water may form on the outside of
the appliance.
Always make sure the installation area is well venti‐
lated. .
-
The more refrigerant there is in the appliance, the
larger the space it is installed in must be. If the
space is too small, any leak may create a flammable
mixture of gas and air. For every 8 g (0.02 lb) size of
the installation space must be at least 1 m
3
(35.5 ft
3
).
Specifications on the refrigerant in the appliance
can be found on the serial tag plate inside the appli‐
ance.
2.1.1 Installation surface
-
The floor of the installation site must be horizontal
and level.
-
The height of the appliance base must be the same
as the surrounding floor.
2.1.2 Installation position
-
Do not install the appliance in direct sunlight or next
to an oven, heater, or similar heat source.
-
Always stand the appliance backed directly to the
wall using the enclosed wall spacers (see below).
2.2 Fitting the appliance into the
kitchen unit
The appliance can be built into kitchen cabinets.
Setup conditions
* Depending on model and options 3
Loading ...
Loading ...
Loading ...