Loading ...
Loading ...
Loading ...
assembly
MOUNTING JOINTER-PLANER ON RECOM-
MENDED CRAFTSMAN STAND
(NOT SUPPLIED IN CANADA)
See page 27 for recommended stand.
PARTS NEEDED
Nuts, Bolts and Washers removed when unpacking Jointer.
1 - Round Hd. Mach. Screw t/4-20 x 1-t/4 in. with Ext.
Tooth Lockwasher attached
1 - Depth of Cut Handwheel
TOOLS NEEDED
1/2 in. Wrench
Medium Screwdriver
1, Loosen FENCE LOCK KNOB.Tilt fence upward and slide
{t toward the pulley.
2, Place the machine on the stand as shown, and align
mounting holes.
3. Place a fiat washer, a lock washer and a nut on each boff
from underneath the stand and tighten.
NOTE: The length of threads may vary on some bolts
and it may be necessary to add extra flat washers in order
to tighten the nuts securely,
FENCE LOCK
KNOB
1-1/4 IN. SCREW
It _.,2"/ _ _ FLAT WASHER
4, Place handwheel on shaft aligning flat surfaces on shaft
with flat surfaces on handwheel,., attach with 1-1/4 in.
screw.
.....: ......................................... i,,, i i nl i i.,
CHECKING CUTTER BLADES AND SCREWS
TOOLS NEEDED
5/32" and 1/8" Setscrew Wrenches (furnished with
Jointer).
Lead Pencil
Short straight edge (or head of combination square)
1. Insert pencil in space at end of cutterhead to hold
cutterhead guard open.
2. Lower the infeed table with the Depth of Cut
HandwheeL
3. Rest the straight edge on edge on the surface of outfeed
table so it extends across the opening between the
tables, at three positions: near each end and at the
middle of the cutter blade.
4, Rotate the cutterhead by grasping the 2" dia. driven
pulley and make sure each knife ticks (touches) the
straight edge at all three positions, If not, follow
procedure under "REPLACING CUTTER BLADES" on
ppg. 22 & 23.
OUTFEED TABLE
WEDGE
5/32 IN. SETSCREW
WRENCH
PENCI L
CUTTER GUARD
5. If a cutter blade adjustment is not required, check each
locking screw of each wedge (5/32" setscrew wrench)
and tighten if necessary. Hold the pu{le¥ whiie
tightening screws and be careful that your fingers do not
slip off the wrench."
7
Loading ...
Loading ...
Loading ...