Loading ...
Loading ...
Loading ...
trouble
shooting
WARNING: FOR YOUR OWN SAFETY, TURN SWITCH
"OFF" AND REMOVE PLUG FROM POWER SOURCE
OUTLET BEFORE TROUBLE SHOOTING YOUR JOIN-
TER*PLANER.
TROUBLE SHOOTING CHART
TROUBLE
,J,ll,u
Motor will not run, i'.
,,,i,, ,ll, ,, ,
Wood strikes outfeed
table after passing over
cutter head.
Ripples on planed
surface.
i,,,i, i i ii i
Planed surface not
straight.
Excessivegougingat end
of cut.
90° and 45 ° cuts
inaccurate.
,,LI i i i i
Infeed table loose.
Cutter guard does not
function properly.
PROBi_BLE CAUSE
I, Defective On-Off switch,
Defective switch cord.
Defective switch box receptacle.
2, Motor protector open, (only if
your motor is equipped with an
overload protector).
Other cause
,,J,_ _,J J, ,,,J,,
REMEDY
Replace defective parts before using
machine again.
2. Consult Sears Service. Any attempt to
repair this motor may create a HAZARD
unless repair is done by a qualified service
technician. Repair service is available at your
nearest Sears Store.
J"L''_J_'L"LLJ.... III I I I "' ""1 ' I1
Blades improperly adjusted below Re-adjust blades, see Maintenance section,
Isurface of outfeed table.
1. One blade set higher than other, t. Re-adjust blades, see Maintenance
section.
2. Feeding wood too fast. 2. Feed wood slower.
..=l.l,, i, i i, i i ................................. H ii
Infeed table out of adjustment. Re-adjust infeed table, see Getting To Know
your Jointer Planer section.
Blades set too high above outfeed Reset blades, see Maintenance section.
table.
1,,,,,,uu,w , . i
1, Fence stops not adjusted properly. 1. Re-adjust fence stops, see Getting To
Know your Jointer PJaner section,
2. Fence slide bracket not even with
table.
u.i ,H. IH... I I II . I .HH..I I H I IL
t. Dovetail spacer requires adjustment.
2. Female dovetail loose from table.
1. Return spring broken, or spring
has been weakened.
2. Improper assembly of spring or
guard mounting.
2.
[
1.
2.
1.
Re-adjust slide bracket, see Getting To
Know your Jointer Planer section.
Hl,.i i, ,i, i,lll, , ,
Tighten screw, key 10, seefig. 2, Parts List.
Tighten screws, key 18, seefig. 2, Parts List.
Replace spring immediately. See
Maintenance section,
2. See Maintenance section,
IN CANADA, SEE YOUR LOCAL SIMPSONS-SEARS STORE
OR CATALOG FOR ACCESSORY SELECTION AND NUMBERS
RECOMMENDED ACCESSORIES
ITEM CAT.NO.
Floor Stand ............................. 9-22216
Cutter Blades ............................ 9-2293
Power Tool Know-how Handbooks
Radial Saw ........................ 9-29t7
Table Saw ............................. 9-29!8
Knife Setting Gauge ....................... 9-2647
The above recommended accessories are current and were
available at the time this manual was printed.
27
Loading ...
Loading ...
Loading ...