Loading ...
Loading ...
Loading ...
.getting toknow your iointer-ploner
b.
Insert a pencil in space at end of cutterhead to
hold cutterguard open.
Place a straightedge (large square or long level) on
outfeed table. First along one side than along the
other.
c. Raise infeed table until it touches straightedge.
d.
Sight between table and straightedgeto determine
high or low condition of end of infeed table.
ROTATE
BLADE OUT OF
PENCIL
It is easier to adjust the infeed table while the Jointer is
setting on your workbench.
Do not turn the Jointer on its side or upside down to
adjust it.
Attach a stripof wood to two blocks of wood 10 in. high.
Drive enough nails into the strip so that Jointer does
not tip over while resting on blocks.
i
t
a. Remove motor cord from outlet in switch box,
b, Remove,joir_ter pulley guard and V:belt ..........
:, c. Remove Jointer from stand.
::: :::d, Lower theinfeed table,
: :::e. Place Jointe_ioh biocksill_
• . •_: :i _i_¸::I•: : "
.... .... ......... • ii!i___i _i, :_ii;_:_ i'=_i _L,,,:,,,,,,,,II,I::?_
10 IN,
BLOCKS
: : OF WOOD
.i Ill
YOUR WORK
BENCH
f. Insert a pencil in space at end of cutterhead to
hold cutterguard open,
g. Wrapa piece of cardboard aroUnd::cutterhead to
iprotect your fingers and the blades : . . secure
:cardboard with a piece of tape. ,
i i_i_i ii_i_i_i_i _: i : i_!_iii_IL!__ii, :ii_i !i_;!ii!;i_i _
PENCIL
t
CARDBOARD"
•16
Loading ...
Loading ...
Loading ...