Warmlite WL45033N Hingham Wall Mounted Fireplace Suite

INSTRUCTION MANUAL - Page 13

For WL45033N.

PDF File Manual, 16 pages, Read Online | Download pdf file

WL45033N photo
Loading ...
Loading ...
Loading ...
13www.warmlite.co
SAFETY CUT-OUT
This appliance is tted with a safety cut-o
which will operate if the re overheats (e.g. due
to blocked air vents). For safety reasons, the
re will NOT automatically reset.
To reset the appliance, disconnect the
appliance from the mains supply for at least 15
minutes. Reconnect to the mains supply and
switch on the appliance.
CAUTION: Do not touch the heater as it will be
hot. Set the heater switches to OFF and leave
the heater to cool down fully. Once completely
cool, reconnect the heater and switch it on.
Do not open this product. There are no user-
serviceable parts inside.
CHECK THAT YOU HAVE NOTED ALL THE
FOLLOWING INSTRUCTIONS:
Do’s
Always install the re in accordance with
this guide. If in doubt obtain expert advice.
Always make sure the electrical socket is
accessible and located adjacent to, but
not above or behind the re.
Always disconnect the re from the
electrical supply before carrying out
cleaning or maintenance.
Always make sure the re is rmly
secured.
Always assemble the re in accordance
with this guide. If in doubt, obtain expert
advice.
Always ensure the product is assembled
in an area that is free from dust, grease or
liquids.
Always ensure that the correct tools are
used to assemble/install this product.
Always make sure the re is rmly secured
in place when complete.
Dont’s
Never leave children unsupervised in a
room where the re is ON and unguarded.
Never obstruct or cover the fan outlet or
force items into re openings.
Never install or use the re anywhere
where water is in use, i.e. bathrooms,
kitchens, shower rooms, and swimming
pool etc.
Never use aerosols or steam cleaners on
or around the re.
Never route the mains supply cable under
carpet etc.
Never install the re close to curtains or
combustible materials.
Never use the re to dry clothes etc.
Never sit or stand on the re.
Never cut the o the plug and hard wire
into a xed fused spur.
Note: Any new wiring required, must be in
accordance with local and national codes and
other applicable regulations in order to reduce
the risk of re, electric shock, or other injuries.
Note: When the re is turned on for the rst
time or when it has not been used for some
time, it may release a slight, harmless odour.
This odour is a normal occurrence caused
by the initial heating of the internal heating
elements or dust, and will disappear with use.
TROUBLE SHOOTING
Safety Cut-Out device:
To ensure against the potential hazard
caused by blockage of the air outlet, this
unit is equipped with an automatic over-
temperature safety cut-out device. When the
device is activated the heater will not operate.
If this occurs, the unit can be reset using the
following procedure.
1. Turn the re o by depressing the on/o
switch on the unit.
2. Unplug the power cord form the electrical
mains supply socket and leave it
disconnected for at least 15 minutes.
3. Ensure that the air vents are free from
obstruction.
4. Plug the power cord back in to the mains
socket.
Loading ...
Loading ...
Loading ...