Loading ...
Loading ...
Loading ...
Slot in Positive Terminal
Frame (Inside
Negative
Cable
FIGURE 4.
Negative
Terminal Battery
Opening
FIGURE 5.
| lattery
Strap
° ?ral_n'/f'__ __
°
CableTra" _'--r saxle
Tie Remfo 'cement
Br_cket
INSTALLING THE BATTERY
1. Lift the seat.
2. Make certain both the negative (black) cable and
the positive (red) cable are routed up through the
battery opening as shown in figure 4.
3. Replace the battery into the battery opening in
the same position as it was before (positive termi-
nal is toward the front of the unit).
4• Attach the positive (red) cable to the positive ter-
minal of the battery. Secure with hex bolt and nut
previously removed• Slide rubber boot down over
the positive terminal.
5. Remove the hex bolt and nut from the negative
(black) cable• Attach negative cable to the nega-
tive terminal with this bolt and nut.
6. Secure battery by hooking battery strap into slot
in frame.
•
Route the drain tube through the opening
between the transaxle reinforcement bracket and
the frame on the left rear of the unit. Insert the
drain tube to the transaxle reinforcement bracket
through the cable tie which is attached as shown
in figure 5. Be certain drain tube is routed away
from the wheel rim.
8• Draw cable tie secure, but do not overtighten or
the drain tube could collapse• Trim excess end of
cable tie.
CONTROLS
Clutch-
Brake
Pedal
FIGURE 6,
Throttle
Control
Ignition
Switch
J )
Speed
Control
Lever _
THROTTLE CONTROL
The throttle control is used to regulate the engine
speed. To get maximum efficiency from cutting, the
throttle should be in the FAST position when operat-
ing the mower. See figure 6.
CHOKECONTROL
The choke control is located on the dashboard and is
operated manually. Details for the choke operation
are covered in the separate engine manual packed
with your unit. See figure 6.
SPEED CONTROLLEVER
The speed control lever allows you to regulate the
ground speed of the lawn tractor. See figure 6. To
select the ground speed, depress clutch pedal• Push
speed control lever inward and move downward to
slow lawn tractor, move upward to increase speed•
When desired speed has been obtained, release lever
in that position. Whenever clutch is engaged, unit will
automatically go to the pre-set speed.
Loading ...
Loading ...
Loading ...