Loading ...
Loading ...
Loading ...
Hex Bolts Hex Bolts
Lock Lock Vrashers
Washers Hex N=
Hex Nuts
FIGURE 17.
Belt Guards
J
Removing the Rear Drive Belt (Refer to fig ire 18)
1. Start the engine. Place shift lever in neutral.
Place speed control lever in high speec position
and turn engine off. Engage lift lever (mo/e all the
way forward). Do not set parking brake.
2. Disconnect the large spring from the trar smission
support bracket, using a spring puller or other
suitable tool.
Idler
Variable Loosen
Speed Pulley Nut
Idler
,- Pulley
5. Remove belt from transmission pulley and idler
pulley. Remove the rear drive belt from around
the top of the variable speed pulley.
6. Reassemble new belt, following instructions in
reverse order.
Removing the Forward Drive Belt (See figure 19)
1. To remove the forward drive belt, first remove the
rear drive belt (steps 1 through 5 of the preceding
instructions).
2. Remove the deck belt from the engine pulley
(steps 1through 3 of "Removing The Deck Belt").
3. Remove the engine pulley belt guard by removing
two self-tapping screws from each side of the
frame. Remove the engine pulley belt guard by
moving it back and to the left.
4. Remove the forward drive belt from the engine
pulley and from the variable speed pulley.
5. Reassemble new belt, following instructions in
reverse order.
Engine
Pulley
Engine Pulley
Belt Guard
Forward
Belt
Variable
S
Pulley
FIGURE 18. FIGURE 19.
3. Disconnect the idler spring from the b( It on the
right side of the frame and transmissiom_ support
bracket.
4. Loosen (do not remove) the hex nmJtwhich
secures the variable speed pulley brack_ t to allow
clearance in order to remove the belts A 9/16"
socket wrench is required.
14
BATTERYCAREAND MAINTENANCE
CHECK FLUID LEVEL
Check fluid level inside each cell of the battery every
two weeks and before and after charging. Always
keep level just below the split rings.
Loading ...
Loading ...
Loading ...