Craftsman 917273321 tractor

User Manual - Page 24

For 917273321.

PDF File Manual, 68 pages, Download pdf file

Loading ...
Loading ...
Loading ...
TOLEVELMOWER HOUSING.
Adjust the mower while tractor js parked
on level ground or driveway. Make sure
tires are properly inflated (See "PROD-
UCT SPECIFICATIONS'). If tires are
over or underinflated, you will not properly
adjust your mower.
SIDE-TO-SIDE ADJUSTMENT '
Raise mower to its highest'position.
Measure height from bottom of deck
cud to ground level at front comers of,
mower. Distance "A" on both Sides of
mower should be the same.
If adjustment is necessary, make adjust-
ment on one side of mower only.
To raise one side of mower, tighten lift
link adjustment nut on that side.
To lower one side of mower, loosen lift
link adjustment nut on that side.
NOTE: Each full tum of adjustment nut
will change mower height about 3/16".
Recheck measurements after adjusting.
Bottom
Bottom
o,
FRONT-TO-BACK ADJUSTMENT
IMPORTANT: Deck must be level side-to-
side. If the following front-to-back adjust-
ment is necessary,,be sure to adjust both
front links equally so mower will stay level
side-to-side.
To obtain the best cutting results, the
mower housing should be adjusted so the
front is approximately 1/8" to 112" lower
than the rear when the mower is in its
highest position.
Check adjustment on right side of tractor.
Measure distance "P directly in front of
and behind the mandrel at bottom edge of
mower housing as shown.
Beforemaking any necessary adjust-
ments, check that both front links are
equal in length.
If links are not equal in length, adjust
one link to same length as other link.
To lower front of mower housing, loosen
nut "G" On both front links an equal
number of tums.
When distance =P is 1/8" to 1/2" lower
at front than rear, tighten nut =H" against
trunnion on both front links.
To raise front of mower housing, loosen
nut "H" from trunnionon both front links.
Tighten nut "G" on both front links an
equal number ofturns.
When distance "P is 1/8" to 1/2" lower
at front than rear, tighten nut "H"
against trunnion on beth front links.
NOTE: Each full turn of nut "G" will
change dim. =P by approximately 318".
Recheck side-to-side adjustment.
Mandrel
_ oo
o o o
Nut =H"_
Trunnion -I- _
Firn¢i_t.._____ _-----'"_%
)
"_ Nut =G"
?
TO REPLACE MOWER DRIVE BELT
MOWER DRIVE BELT REMOVAL
Park tractor on a level surface. Engage
parking brake.
Remove screws from left hand mandrel
cover and remove cover.
Roll belt over the top of left hand man-
drel pulley.
Remove belt from electric clutch pulley.
Remove belt from idler pulleys.
Remove any dirt or grass clippings
which may have accumulated around
mandrels and entire upper deck sur-
face.
Check primary idler arm and two idlers
to see that they rotate freely.
Be sure spring is securely hooked to pri-
mary idler arm and bolt in mower hous-
ing.
24
Loading ...
Loading ...
Loading ...