1. Home
  2. Ancona
  3. Ancona AN-22125SS User Manual
  4. Page 9

Ancona AN-22125SS 2-piece Kitchen Appliance Package with 36" 6-burner Gas Cooktop & Wall Range Hood

User Manual and Installation Instructions - Page 9

For AN-22125SS. Also, The document are for others Ancona models: AN-2160, AN-2161, AN-2162, AN-2230SS, AN-2236SS, AN-2248SS, AN-2230WHT, AN-2236WHT, AN-2248WHT, AN-2230SSBK, AN-2236SSBK, AN-2248SSBK

PDF File Manual, 56 pages, Read Online | Download pdf file

Loading ...
Loading ...
Loading ...
— 9 —
STEP 1
Read the Safety Instructions
•It is very important to read the safety instructions on pages 4 and 5.
IMPORTANT: It is the installer’s responsibility to comply with installation clearances.
STEP 2
Unpack Range Hood and Prepare Tools
•Carefully unpack the range hood and parts. Make sure all parts are included as shown on page 6.
•DO NOT remove the protective lm covering the appliance until the installation is fully completed.
•Consult a qualied and trained installer or check local codes for makeup air requirement, if any.
STEP 3
Plan Desired Location
•Plan a desirable location that ts all requirements in the Safety and Installation sections of this manual. Plan where
and how the ductwork will be installed.
•A straight or short duct run will allow the unit to perform most efciently. Long duct runs, elbows and transitions
will reduce the performance of the unit. Each elbow is equivalent to 5 to 10 feet (1.5 m to 3 m) of straight run.
Propersizeductworkshouldbe6in.(15.3cm)indiameter.
•To reach a 9 ft (2.7 m) ceiling make sure hood is installed 30 inches (
76.2 cm)
from cooking surface. If you
have a ceiling greater than 9 ft (2.7 m), please visit anconahome.com to order a chimney extension.
•If ductwork is already installed: ensure ductwork is free from debris and measures
6 in. (15.3 cm).
1 in. (2.5 cm)
reducers may be used but more than 1 in. (2.5 cm) will overwork the motor and the unit will not function properly.
STEP 4
Test Unit Functions
•Plug the unit in and test all of the functions before installing.
•Placetherangehoodonaat,stablesurface.Connecttherangehoodtoadesignatedstandardoutlet(120-Volt,60Hz,
AC only) and turn on the range hood. Verify all operations of the range hood by referring to
Range Hood Operations.
•Turn power On in control panel.
•Check all lights and fan operations.
WARNINGS:
•PleasemakesuretoreadALLsafetyinstructionsonpages4and5.
•Usetwoormorepeopletomoveandinstallrangehood.
•Failuretofollowtheseinstructionscanresultinseriousinjury.
Installation
Loading ...
Loading ...
Loading ...