1. Home
  2. Ancona
  3. Ancona AN-22125SS User Manual
  4. Page 14

Ancona AN-22125SS 2-piece Kitchen Appliance Package with 36" 6-burner Gas Cooktop & Wall Range Hood

User Manual and Installation Instructions - Page 14

For AN-22125SS. Also, The document are for others Ancona models: AN-2160, AN-2161, AN-2162, AN-2230SS, AN-2236SS, AN-2248SS, AN-2230WHT, AN-2236WHT, AN-2248WHT, AN-2230SSBK, AN-2236SSBK, AN-2248SSBK

PDF File Manual, 56 pages, Read Online | Download pdf file

Loading ...
Loading ...
Loading ...
— 14 —
IMPORTANT:
•Observeallgoverningcodesandordinances.
•It is the customer’s responsibility to contact a qualified electrical installer.
•Ifcodespermitandaseparategroundwireisused,itisrecommendedthataqualifiedelectriciandeterminethat
thegroundpathisadequate.A120-Volt,60Hz,AC-only,fusedelectricalsupplyisrequiredonaseparate15-amp
circuit, fused on both sides of the line.
•DONOTgroundtoagaspipe.
•Checkwithaqualifiedelectricianifyouarenotsurethattherangehoodisproperlygrounded.
•DONOThaveafuseintheneutralorgroundcircuit.
IMPORTANT: Save this Installation Guide for electrical inspector’s use.
GROUNDING INSTRUCTIONS:
•Thisappliancemustbegrounded.Intheeventofanelectricalshort-circuit,groundingreducestheriskofelectric
shock by providing an escape wire for the electric current.
•Thisapplianceisequippedwithacordhavingagroundingwirewithagroundingplug.Theplugmustbeplugged
into an outlet that is properly installed and grounded.
WARNING: Improper grounding can result in a risk of electric shock.
•Consultaqualifiedelectricianifthegroundinginstructionsarenotcompletelyunderstood,orifdoubtexistsasto
whether the appliance is properly grounded. DO NOT use an extension cord. If the power supply cord is too short,
have a qualified electrician install an outlet near the appliance.
STEP 14
Install Filters
To install lters, see following four steps (see Figure 8):
•Angle the lter into slots at the back of the hood.
•Push the button on handle of the lter.
•Release the handle once the lter ts into a resting position.
•Repeat to install all lters.
Installation
Figure 8
STEP 13
Connect to AC
•ConnectACplugintoagroundedACoutlethaving120V,60Hz.Placetheoutletatamaximumdistanceof33-1/2in.
(851 mm) from where the cord exits on the hood.
•SEE IMPORTANT INSTRUCTIONS BELOW.
3-Pronged Plug
Ground Plug
3-Prong Receptacle
Loading ...
Loading ...
Loading ...