Loading ...
Loading ...
Loading ...
Page 12
OPERATION
To blow the sawdust, turn the switch to the
position .
To turn off the blowing function, turn the
switch to the
position .
ADJUSTING THE CUTTING
ANGLE (FIG. 6)
a
b
c
FIG. 6
Bevel Lock Lever
Detents
Base
Your tool features detents on the base that
let you quickly set the base to make bevel
cuts at angles of 0°, 15°, 30°, and 45° left
or right.
To adjust the base angle:
1. Disconnect the battery pack.
2. Pull the bevel lock lever as far as it will go
in the direction shown.
3. Move the base slightly forward to
disengage the locking tab from the
detent.
4. Position the base to the desired bevel
angle (0°, ±15°, ±30° or ±45°).
5. Pull the base backward to engage the
locking tab into a detent and retighten
the base-adjustment lever to maintain
the bevel angle. After adjusting the base,
make a sample cut to check the angle.
ORBITAL-ACTION SETTINGS
(FIG. 7)
Your tool is equipped with four orbital-action
settings to best match the cutting speed,
capacity, pattern, and the material being cut.
The orbital action can be adjusted with the
orbit-control lever (Fig. 7). The optimal or-
bital action setting for the respective appli-
cation can be determined through test cuts.
Refer to the following table:
Lever
position
Cutting action Application
0
Straight line cutting
action
For cutting mild steel, stainless steel and plastics.
For clean cuts in wood and plywood.
1 Low orbital action For cutting mild steel, aluminum and hard wood.
2 Medium orbital action
For cutting wood and plywood. For fast cutting in
aluminum and mild steel.
3
Maximum orbital
action
For fast cutting in wood and plywood.
Loading ...
Loading ...
Loading ...