Loading ...
Loading ...
Loading ...
Page 10
INSTALLING AND REMOVING
THE SAW BLADE (FIG. 2)
The tool can only accept most commonly
available T-shank blades.
To install the saw blade (FIG. 2a):
1. Disconnect the battery pack.
2. Insert the blade, with its teeth facing
outward as shown in FIG. 2a, into the slot
of the blade holder as far as the blade
can go. The blade will automatically
lock in place.
3. Pull down on the blade to verify that the
blade is securely locked in place.
NOTICE: When inserting the saw blade, the
back of the blade must rest in the groove of
the guide roller.
FIG. 2a
Blade
Holder
Guide
Roller
To remove the saw blade (Fig. 2b):
WARNING:
Always wear
protective gloves when removing the saw
blade from the tool. The saw blade is sharp
and may be hot after prolonged use.
1. Disconnect the battery pack.
2. Turn the blade release lever as shown
and remove the saw blade.
3. Release the blade release lever.
FIG. 2b
Blade
Release
Lever
INSTALLING/REMOVING THE
COVER PLATE (FIG. 3)
Use the cover plate when cutting decora-
tive veneers, plastics, etc. It protects sensi-
tive or delicate surfaces from damage. It is
mounted on the bottom of the tool base.
To install the cover plate:
1. Disconnect the battery pack.
2. Insert the front of the base into the front
of the cover plate and lower the jig saw.
The cover plate should snap securely
and audibly onto the rear of the base
(FIG. 3a).
1
2
FIG. 3a
OPERATION
Loading ...
Loading ...
Loading ...