Loading ...
Loading ...
Loading ...
Page 13
NOTE: Always make test cuts in scrap
material rst to determine the best orbital
setting.
In order to reach full orbital action, the blade
must be facing straight forward, the back
of the blade must be resting in the groove
of the guide roller. Orbital action is not
detectable when the saw is running under
no load. The saw must be cutting in order
for orbital action to occur. The effect of
the orbital action is more noticeable when
cutting thicker material.
FIG. 7
Orbit-Control Lever
LOCK-OFF BUTTON (FIG. 8)
FIG. 8
Lock-off Button
Your tool is equipped with a lock-off button,
located above the variable-speed trigger
switch, to help prevent the saw from being
turned on unintentionally.
OPERATION
To lock the saw, depress the lock-off button
from the side marked with icon .
To unlock the saw, depress the lock-off
button from the side marked with icon
.
VARIABLE-SPEED TRIGGER
SWITCH (FIG. 9)
FIG. 9
Variable-Speed Trigger Switch
Your tool is equipped with a variable-speed
trigger switch. The tool can be turned on or
off by depressing or releasing the trigger.
The variable-speed trigger switch delivers
higher speed with increased trigger pressure
and lower speed with decreased trigger
pressure.
1. To start the saw, depress the lock-off
button to the unlock position, and then
squeeze the variable-speed trigger switch.
2. To stop the saw, release the variable-
speed trigger switch and depress the
lock-off button to the locked position.
Loading ...
Loading ...
Loading ...