Loading ...
Loading ...
Loading ...
Operation & Installation
6
This portable ice maker uses a fully-automatic control system, with an advanced microcomputer for
easy and convenient ice making. Making ice is simple and fast. Just add water, plug into an outlet, and
press the ON/OFF button. You can select one of the two ice cube sizes with the touch of a button.
When first turning on the unit or during ice-making cycles, the compressor will stay idle for 3 minutes,
while energizing.
There are warning indicators that alert you to fill water when the reservoir is empty, and to remove ice
when the storage basket is full. The icemaker also has built-in safeguards that can limit accidental
damage, automatically shutting down the system when necessary.
The incline angle of the ice maker cabinet should not exceed 45˚ during transportation or use. Do not
turn the icemaker upside down. Inverting the ice maker could cause the compressor or refrigerating
system to operate incorrectly. When the ice maker is moved or transported, please allow time for the
fluids in the compressor to settle. Before using the ice maker for the first time, please wait 2 hours
after the unit has been leveled and positioned in its proper place.
Please ensure the ice maker is level and on a stable table or platform to avoid malfunction.
The machine must be placed on a dry and level surface with sufficient ventilation, far from heat
sources such as ovens, heaters and corrosive gases. Leave an 8" (20 cm) clearance on all sides of
the ice maker for proper ventilation.
Do not fill the water reservoir with hot water. This may damage the ice maker. It is best to fill the
water reservoir with water of room temperature or lower.Please ensure the ice maker is level and on
a stable table or platform to avoid malfunction.
BEFORE FIRST USE
PREPARING YOUR ICE MAKER
Remove the exterior and interior packaging.
Make sure that the ice basket and ice scoop are inside. If any parts are missing, please contact
customer service.
Remove the tape holding the ice scoop and ice basket.
Clean the tank and ice basket with diluted detergent, warm water, and a soft cloth.
Allow one hour for the refrigerant fluid to settle, then plug the ice maker in to a grounded wall outlet.
Prior to using your ice maker each time, wipe out the interior with a clean,damp cloth.
Making Ice Ensure that the drain plug underneath the front of the unit is closed and the water tube
screen is in place.
Plug the ice maker into the wall outlet and the green power indicator light.
Open the cover and remove the ice basket.
Fill the water reservoir. NOTE: do not fill above the max water level mark at the back of the
water reservoir.
Replace the ice basket and close the cover.
Press the ON/OFF button and the green POWER LED will light signifying that the unit is on.To
change between either the small or large ice size, press the SELECT button until the desired ice size
is indicated.
USE YOUR ICE MAKER
Note:
Loading ...
Loading ...
Loading ...