Loading ...
Loading ...
Loading ...
-7-
V. d - CLEANING THE INTERIOR
For cleaning both stainless steel and anodized aluminum
interiors, the use of baking soda as described in section “V.
c” is recommended. Use on breaker strips as well as door
gaskets. All interior fittings are removable without tools to
facilitate cleaning.
V. e - ADJUSTING THE SHELVES
For shelves mounted on pins, first select the desired location
and remove the white plastic covers in the interior back and
sides by rotating them counter-clockwise. Remove the shelf
pins by rotating them counter-clockwise. Install the pins in
the desired location by rotating clockwise. Make sure the
pin is securely tightened down. Do not over tighten. Slide
the shelf into its new position, and replace the white plastic
covers into the holes vacated by the shelf pins.
V. f - REPLACING THE LIGHT BULB
All Traulsen R & A Series models are supplied with LED
lighting with the exception of heated units. Optional tube
style display lighting is available (except for sliding glass door
models for which fluorescent lights are supplied standard).
The standard LED bulb is a 115 or 230 volt / 4-watt, T-6
intermediate clear refrigerator lamp. It is mounted at the
top front of the cabinet at the center and is located behind a
plastic light cover on refrigerator and freezer model.
Heated units (RHF/AHF/RIH/AIH/RDH/ADH/RIDH/AIDH) are
equipped with a 115 or 230 volt / 25-watt, T-6 incandescent
bulbs. LEDs have not evolved enough yet to take the heat.
This bulb is shatterproof because these models do not
include a plastic light cover.
To replace the bulb, first remove the light cover (if so
equipped). This can be accomplished by squeezing it
together on both sides until it comes free. Replace the light
bulb, then squeeze both sides of the light cover together and
replace in its original position.
V. CARE & MAINTENANCE (continued)
Loading ...
Loading ...
Loading ...