Loading ...
Loading ...
Loading ...
Your new tractor has been assembled at the factory with exceptionof those parts left
unassembled for shipping purposes. To ensure safe and propar operation of your
tractor all parts and hardware you assemble must be tightened securely.Use the
correct tools as necessary to insure proper tightness. Review the video cassette before
you begin.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly
easier. Standard wrench sizes you need
are listed below.
(1) 9/16" wrench (1) Pliers
(2) 1/2" wrench (1) Utility knife
(1) Tire pressure gauge
When rightor left hand is mentioned in
this manual, itmeans, from your pointof
view, when you are in the operating
position (seated behind the steering
wheel)•
TO REMOVETRACTOR FROM
CARTON
UNPACK CARTON
1. Remove all accessible loose parts
and parts cartons from carton.
2. Cut, from top to bottom, along lines on
all four comers of carton, and lay
panels flat.
3. Check for any additional loose parts
or cartons and remove.
BEFORE REMOVINGTRACTOR
FROM SKID
A'rrACH STEERING WHEEL
ASSEMBLE EXTENSION SHAFT AND
BOOT
1. Slide extension shaft onto lower
steedng shaft. Align mounting holes
in extension and lower shafts and
install 5/16 bex bolt and leoknut.
Tighten securely.
IMPORTANT: Tighten boltand nut
securely to 18-22 ft. Ibstorque.
2. Place tabs ofsteoring boot over tab
slots in dash and push down to
secure•
INSTALL STEERING WHEEL
3. Position front wheels of the tractor so
they are pointingstraight forward.
4. Remove steering wheel adapter from
steedng wheel and slide adapter onto
steering shaft extension.
5. Position steering wheel so cross bars
are horizontoi(left to right) and slide
inside boot and onto adapter.
___.__- Insert
_-- 3/8HexBolt
3/8 LockWasher
LargeFlat
Washer
• 5/16
5/16 Hex Boll
Locknut ._ ",,
Lower _ _
' Tab
_.eenh_ ..
Shaft <._ ' Slots
6. Assemble large flat washer, 3/8 lock
washer, 3/8 hex bolt and tighten
securely.
7. Snap steering wheel insert into center
of steering wheel.
8. Remove protective materials from
tractor hood and grill.
IMPORTANT: Check for and remove any
staples in skid that may puncture tire
where tractor isto rolloff skid.
HOWTO SET UPYOURTRACTOR
CHECK BATTERY
1. Lift seat pan to raised positionand
open battery box door.
NOTE: Ifthis batteryis put intoservice
after month and year indicated on label
(label located between terminals) charge
battery for minimum of one hour at 6-10
amps. (See "BATTERY" in Maintenance
section of this manual for charging
instructions).
8
Loading ...
Loading ...
Loading ...