Loading ...
Loading ...
Loading ...
}ELT INSTALLATION -
L Install new belt in reverse order of
removal.
_. Make sure belt is in all pulley grooves
and inside all belt guides.
3. Install mower in reverse order of
removal instructions.
I'0 ADJUST BRAKE
{ourtractoris equippedwith an adjustable
)rake systemwhich is mountedon the
;ide ofthe transaxle.
f tractorrequiresmore than six(6) feet
_opping distanceat high speed in highest
joor on a level dry concrete or paved
_urface, then brake must be adjusted.
1. Depress clutch_rake pedal and
engage parking brake.
2. Measure distance between brake
operatingarm and nut=A"an brake rod.
3. Ifdistance isotherthan 1-9/16", loosen
jam nutand turnnut =A"untildistance
becomes 1-9/16". Refightenjam nut
againstnut"A".
4. Road test tractor for proper stopping
distanceas stated above. Readjust if
necessary, Ifstoppingdistance isstill
greaterthan six (6) foot in highest gear,
furthermaintenance is necessary.
Contact a Sears or other qualified
servicecenter.
With Parking Brake"Engaged"
Operating
Arm
Do Not touchthisnut. Itfurtherbrakeadjust-
ment is necessary contactyour nearest
authorizedservicecenter/department
I'O REPLACE MOTION DRIVE BELT
Park the tractor on level surface. Engage
parking brake. For assistance, there is a
belt installation guide decal on bottom
side of leftfootrest.
t. Remove mower (See =TO REMOVE
MOWER" in this section ofthis
manual,)
2. Disconnect clutch wire harness.
3. Remove clutch locator.
4. Remove belt from stationary idler and
clutching idler.
5. Pull belt slack toward rear of tractor.
Carefully remove belt upwards from
transmission input pulley and over
cooling fan blades.
6. Pull belt toward front of tractor and
remove downwards from around
electdc clutch.
7. Install new belt by reversing above
procedure.
Electdc_
c, °h
Clutchingf I.._
Idler J
Idler
h-..
_J " Clutch
_L._; Wire
InputPulley Harness
TRANSAXLE MOTION CONTROL
LEVER NEUTRAL ADJUSTMENT
The motion control lever has been preset
at the factory and adjustment should not
be necessary.
1. Loosen adjustment bolt in front of the
dght rear wheel, and lightlytighten.
2. Start engine and move motioncontrol
lever untiltractor does not move
forward or backward,
3. Hold motion control lever in that
position and rum engine off.
4. While holding motion control lever in
place, loosen the adjustment bolt.
5. Move motion control lever to the
neutral (N) (lock gate) position.
6. Tighten adjustment bolt securely.
NOTE: If additional clearance is needed
to get to adjustment bolt, move mower
deck height to the lowest position.
After above adjustment is made, if the
tractor stillcreeps forward or backward
while motioncontrol lever is in neutral
position, follow these steps:
1. Loosen the adjustment bolt.
2. Move the motion control lever 1/4 to
1/2 inchin the directionit istryingto
creep.
25
Loading ...
Loading ...
Loading ...