Loading ...
Loading ...
Loading ...
-_EPLACING BAI-FERY
_CAUT ON: Do notshort battery
erminals by allowing a wrench or any
)thor object to contact both terminals at
he same time. Before connectingbattery,
emove metal bracelets, wristwatch
)ands, rings, etc.
=ositive terminal must be connected first
:o prevent sparking from accidental
;rounding.
1. Liftseat pan to raised position and
open battery box door.
2. Disconnect BLACK battery cable first
then RED battery cable and carefully
remove batteryfrom tractor.
3. Install new battery with terminals in
same positionas old battery.
4. First connectRED battery sable to
positive(+) terminal with hex bolt and
keps nut as shown.Tighten securely.
5. Connect BLACK grounding cable to
negative (-) terminal with remaining
hex bolt and keps nut.Tighten
securely.
6. Close battery box door.
Seat
Box
xBolt
Positive(Red)Cable Negative(Black)Cable
TO REPLACE HEADLIGHT BULB
1. Raise hood.
2. Pull bulb holder out of the hole in the
backside of the grill.
3. Replace bulb in holder and push bulb
holder securely back intothe hole in
the backside of the grill,
4. Close hood.
INTERLOCKS AND RELAYS
Loose or damaged widng may cause your
tractorto run poorly,stop running,or
prevent itfrom starting.
• Check wiring. See electrical wiring
diagram in the Repair Parts section.
TO REPLACE FUSE
Replace with 20 amp automotive-typa
plug-in fuse. The fuse holderis located
behind the dash.
TO REMOVE HOOD AND GRILL AS-
SEMBLY
1. Raise hood.
2. Unsnap headlight wire connector.
3. Stand in front of tractor. Grasp hood at
sides, tilttoward engine and liftoffof
tractor.
4. To replace, reverse above procedure.
Hood
Headlight Wire
Connector
ENGINE
Maintenance,repair,or repJ.asemantofthe
emissioncontroldevices and systems,which
are baingdoneat the customersexpanse,
may be performedby any non.roadengine
repairestablishmentor individual.Warranty
repairs must be performed by an authorized
engine manufacturei"s service outlet.
TO ADJUSTTHRO'B'LE CONTROL
CABLE
The throttlecontrol hasbeenpresetat
factoryanda(_ustment should not be
necessary.Check a_ustment as described
below beforeloosening cable.Ifadjustmant is
necessary, proceed as _lows:
1. W'_ enginenot running,move throttle
control leverfrom slow to choke position.
Slowly movelever from choke to fast
position.
2. Check to see ifhole in throttle lever and
holein speedesntrol brecket are aik3_3d.
3. If holesare notaligned,loosen coble
clampscrewand align the hales by
insertinga panci ora 1/4"drillbitthrough
both holes.
4. I%1throtlJecable uptoremove slack and
tighten cable clampscrew. Remove
alignmentpencilordnl bit.
Cable _
Clamp___._
Screw _-_
Speed Control h' _ [
27
Loading ...
Loading ...
Loading ...