Loading ...
Loading ...
Loading ...
SIDE-TO-SIDE ADJUSTMENT
• Raise mower to its highest position.
• At the midpointof both sides of mower,
measure height from bottom edge of
mower to ground. Distance"A" on
both sides of mower should be the
same or within 1/4" of each other.
• Ifadjustment is necessary, make
adjustment on one side of mower only.
• To raise one side of mower, tighten lift
link adjustment nut on that side.
• To lower one side of mower, loosen lift
link adjustment nut on that side.
NOTE: Each full turn of adjustment nut
will change mower height about 1/8".
• Recheck measurements after adjust-
ing.
Bottomedgeof Bottomedgeof
Lift Link _on
Arm
Adjustment Nut
FRONT-TO-BACK ADJUSTMENT
IMPORTANT: Deck must be level side-to
side. Ifthe followingfront-to-beck adjust-
ment is necessary, be sure to adjustboth
front links equally so mower will stay level
side-to-side.
To obtainthe best cutting results, the
mower housing should be adjusted so
that the front is approximately 1/8"to I/2"
lower than the rear when the mower is in
its highest position.
Check adjustment on rightside oftractor,
Measure distance "D" directly in front and
behind the mandrel at bottom edge of
mower housing as shown.
• Before making any necessary adjust-
ments, check that both front links are
equal in length.
• If links are not equal in length, adjust
one link to same length as other link.
• To lower front of mower loosen nut "E"
on both front links an equal number of
turns.
• When distance =D" is 1/8" to 1/2" lower
at front than rear, tighten nuts "P
against trunnion on both front links.
• To raise front of mower, loosen nut "F"
from trunnion an both front links.
Tighten nut "E" on both front links an
equal number of turns.
• When distance "D" is 1/8" to 1/2" lower
at front than rear, tighten nut "F" against
trunnion on both front links.
• Recheck side-to-side adjustment.
__1_[ • o _. Mandrel
BothFrontUnks Shouldbe EqualinLength
Nut =_
Tmnnion_
Front Links
TO REPLACE MOWER BLADE DRIVE
BELT
The mower blade drive belt may be
replaced withouttools. Park the tractor on
level surface. Engage parking brake.
BELT REMOVAL -
1. Remove mower from tractor(See "TO
REMOVE MOWER" in this sectionof
this manual).
2. Work belt off both mandrel pulleys and
idler pulleys.
3. Pull belt away from mower.
Mandrel
Pulle
PuUey
24
Loading ...
Loading ...
Loading ...