Loading ...
Loading ...
Loading ...
21
MAINTENANCE & TROUBLESHOOTING
MAINTENANCE
Cleaning
The recumbent bike can be cleaned with a soft cloth and mild detergent. Do not use abrasives or
solvents on plastic parts. Wipe your perspiration off the recumbent bike after each use. Be
careful not get excessive moisture on the computer display panel as this might cause an
electrical hazard or electronics to fail. Keep the recumbent bike and console out of direct sunlight
to prevent screen damage.
Please inspect all assembly bolts and pedals on the machine for proper tightness every week.
Storage
Store the recumbent bike in a clean and dry environment away from children.
TROUBLESHOOTING
PROBLEM
SOLUTION
The recumbent bike wobbles when in
use.
Turn the rear stabilizer end cap on the rear
stabilizer as needed to level the recumbent bike.
There is no display on the computer
console.
1. Remove the computer console and verify
the wires that come from the computer
console are properly connected to the wires
that come from the front handlebar post.
2. Check if the batteries are correctly
positioned and battery springs are in proper
contact with batteries.
3. The batteries in the computer console may
be dead. Change to new batteries.
There is no heart rate reading or heart
rate reading or is erratic / inconsistent.
1. Make sure that the wire connections for the
hand pulse sensors are secure.
2. To ensure the pulse readout is more precise,
please always hold on to the handlebar grip
sensors with two hands instead of just with
one hand only when you try to test your
heart rate figures.
3. Gripping the hand pulse sensors too tight.
Try to maintain moderate pressure while
holding onto the hand pulse sensors.
The recumbent bike makes a
squeaking noise when in use.
The bolts may be loose on the recumbent bike,
please inspect the bolts and tighten the loose
bolts.
The console does not connect to the
APP.
1. Reset the console, restart the APP, and try
again. The console is reset by holding the
MODE button for 3-4 seconds.
2. Make sure you are using the
MyCloudFitness APP. There is a MCF Plus
APP that is used with our other health
tracking devices, but MCF Plus does NOT
work with this exercise equipment.
3. Check that your smart device has Bluetooth
powered on. Shut down and restart the APP.
Loading ...
Loading ...