Loading ...
Loading ...
Loading ...
15
ASSEMBLY
STEP 6
6A. Removing Hardware- Remove eight Bolts (23) and eight Washers (24) from the Back/Seat
Support Bracket (1) and Seat Sliding Tube (15). Remove bolts with the 6mm Allen
Wrench provided.
6B. Installing the Seat Sliding Tube - Insert the Seat Sliding Tube (15) into the Bushings (54)
of the Rear Main Frame (3). Attach the Seat Sliding Tube (15) to the Back and Seat
Support Bracket (1) with eight Bolts (23) and eight Washers (24) that were removed.
Tighten bolts with the 6mm Allen Wrench provided.
6C. Instalilng the Handlebar –Attach the Handlebar (13) onto the Back and Seat Support
Bracket (1) with two Bolts (70), two Curve Washers (25), two Washers (24), and two Cap
Nuts (32). Tighten bolts with the Multi Hex Tool with Phillips Screwdriver provided.
Connect the Middle Section Hand Pulse Sensor Wires (55) from the Rear Main Frame (3)
to the Hand Pulse Sensor Wire (68) from the Handlebar (13).
HARDWARE PACK
Tool:
Multi Hex Tool with Phillips
Screwdriver
(70) Bolt
2 PCS
(25) Curve Washer
2 PCS
(24) Washer
2 PCS
(32) Cap Nut
2 PCS
6mm Allen Wrench
Loading ...
Loading ...
Loading ...