Neff B59CR7KY0B Built-in oven GB

Manual - Page 23

For B59CR7KY0B.

PDF File Manual, 48 pages, Read Online | Download pdf file

B59CR7KY0B photo
Loading ...
Loading ...
Loading ...
Rails en
23
3.
Start the drying function using
⁠.
a A notification stating that you should carry out the
necessary preparatory work for the drying function
appears on the display.
4.
Press "OK" to confirm the notification.
a The drying function starts. The duration counts down
on the display.
a Once the drying function has run through to the
end, an audible signal sounds.
5.
Leave the appliance door open for 1-2minutes so
that the cooking compartment dries completely.
20  Rails
To thoroughly clean the rails and the cooking compart-
ment, or to replace the rails, you can remove the rails.
20.1 Detaching the rails
WARNING‒Risk of burns!
The shelf supports get very hot
Never touch the shelf supports when hot.
Always allow the appliance to cool down.
Keep children at a safe distance.
1.
Lift the rail forwards slightly and detach it ⁠.
2.
Pull the whole rail to the front and remove it.
3.
Clean the rail.
→"Cleaning products", Page19
20.2 Attaching the rails
Notes
¡ The rails only fit on the right or left.
¡ For both rails, ensure that the curved rods are at the
front.
1.
First, push the rail into the middle of the rear
socket
until the rail rests against the cooking
compartment wall, and then push this back ⁠.
2.
Push the rail into the front socket until the rail
also rests against the cooking compartment wall,
and then press this downwards ⁠.
20.3 Removing the pull-out rail
WARNING‒Risk of burns!
The shelf supports get very hot
Never touch the shelf supports when hot.
Always allow the appliance to cool down.
Keep children at a safe distance.
Notes
¡ Depending on the appliance type, you must change
the basic settings for the telescopic rails for appli-
ances with rails and pull-out rails.
→"Basic settings", Page16
¡ The pull-out rails can be installed at any level as re-
quired.
¡ If necessary, you can equip all levels with a pull-out
rail.
1.
Push on the side of the tab marked PUSH behind
the rail, and push the rail to the rear.
2.
Press and hold PUSH and swing the rail out-
wards until the front retainer is detached.
a
Loading ...
Loading ...
Loading ...