Loading ...
Loading ...
Loading ...
WARNING: To prevent serious personal injury,
never leave the saw unattended until the blade has come
to a complete stop.
• With the exception of the workpiece and related support devises, clear everything off the saw table before turning the
saw on.
• Properly support round materials such as dowel rods or tubing because they have a tendency to roll during a cut, causing
the blade to “bite.” To avoid this, always use a “V” block or clamp workpiece to a miter gauge.
• Before removing loose pieces from the saw table, turn saw off and wait for all moving parts to stop.
FIG. 11
A
A
Page 20
OPERATION
CAUTION: After saw is turned on, a hesitation
before blade movement is normal. Always wait for the saw
to come to a complete stop before restarting.
ON/OFF SWITCH (Fig. 11)
• To turn the saw On, press the button “ ” on the on/off
switch (A).
• To turn the saw Off, press the lower button on the on/off
switch (A).
FIG. 12
USING VARIABLE SPEED (Fig. 12)
You scroll saw has a variable speed knob (A). By turning the
knob, the variable speed control may be adjusted from the
high speed of approximately 1600 RPM to the low speed
of approximately 400 RPM. Suggested speeds are referred
to the section “Blade Selection”.
• Turn the variable speed knob (A) to adjust the blade speed
to the desired setting. Turning the knob clockwise increases
speed. Turning it counterclockwise reduces speed.
Loading ...
Loading ...
Loading ...