Loading ...
Loading ...
Loading ...
45
30
15
0
Page 14
ASSEMBLY
CAUTION: Make practice cuts on scrap wood to
check if the bevel angle settings are correct before important
angle cuts.
FIG. 6a
FIG. 6b
FIG. 6c
SQUARING THE WORK TABLE TO THE
BLADE (Fig. 6a-6c)
• Loosen drop foot lock knob (A), move the drop foot
assembly(B) upward as far as possible.
• Loosen the bevel lock knob (C) to tilt the work table until
it is approximately perpendicular or at right angle to the
blade.
• Place a combination square (D) on the work table (E) next
to the saw blade (F).
• Loosen the screw (G) holding the bevel indicator (H). Move
indicator to the 0° mark and securely tighten screw.
Remember, the bevel scale (I) is a convenient guide but
should not be relied upon for precision. Make practice
cuts on scrap material to determine if your angle settings
are correct.
B
C
D
H
F
I
A
G
E
Loading ...
Loading ...
Loading ...