Loading ...
Loading ...
Loading ...
ASSE BLY
Your new tractorhas been assembled at the factory withexception of those parts left unassembled for shipping purposes.
To ensure safe and proper operation of your tractor a_l parts and hardware you assemble must be tightened securely.
Use the correct tools as necessary to insure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set wilt make assembly easier. Stan-
dard wrench sizes are listed.
(1) 9/16" wrench (1) 3/4" wrench
(2) 1/2" wrenches Tire pressure gauge
Utility knife
When right and left hand are mentioned in this manual, it
means when you are in the operating position (seated be-
hind the steering Wheel).
TO REMOVE TRACTOR FROM CARTON
UNPACK CARTON
Remove all accessible loose partsand parts cartons
from carton (see page 5).
i Cut along lines on carton, from top to bottom, all four
corners of carton and lay panels fiat.
= Check for any additional loose parts or cartons and
remove.
BEFORE ROLLING TRACTOR OFF SKID
ATTACH STEERING WHEEL (See Fig. 1)
ASSEMBLE EXTENSION SHAFT AND BOOT
• Slide extension shaft onto lower steering shaft. Align
mounting holes in extension and lower shafts and
install 5/16 hex b01tand Iocknut. Tighten securely.
IMPORTANT-" TIGHTEN BOLT AND NUT SECURELY
TO t8-22 FT.LBS TORQUE.
= Place tabs of steering boot over tab slots in dash and
push down to secure.
INSTALL STEERING WHEEL
• Position front wheels of the tractor so they are poLnt-
ing straight forward.
- Slide steering wheel adapter onto steering shaft ex-
tension.
= Position steering wheel so cross bars are horizontal
(left to dght)and slide inside boot and onto adapter.
• Assemble large flat washer, 3/8 lock washer, 3/8 hex
bolt and tighten securely.
• Snap steering wheel insert into center of steering
wheel.
• Remove protective materials from tractor hood and
grill.
IMPORTANT: CHECK FOR AND REMOVE ANY STA-
PLES IN -SKIDTHAT MAY PUNCTURE TIRES WHERE
TRACTOR IS TO ROLL OFF SKID.
iNSERT
3/8 HEX BOLT
318LOCK
WASHER
_ LARGE FLAT
WASHER
STEERING
WHEEL
STEERING
BOOT
TABS
FIG. 1
TO ROLL TRACTOR OFF SKID (See Operation
section for location and function of controls)
"- Pressliftlever plunger and raise attachment lift lever
to itshighestposition.
- Release parking brake by depressing clutch/brake
pedal.
- Place gearshift lever in neutral (N) position.
• Rolt tractor forward off skid.
Remove banding holding discharge guard up against
tractor.
6
Loading ...
Loading ...
Loading ...