Loading ...
Loading ...
Loading ...
TROUBLESHOOTING POINTS
PROBLEM
Engine continues to tun
when operator leaves seat
with attachment clutch
engaged
Poor cut - uneven
Mower blades will not
rotate
Poor grass discharge
Headlight(s) not working
(if so equipped)
Battery wilt not charge
Engine "backfires"
when turning engine
"OFF"
i ....................
CAUSE
1. Faulty operator-safety presencecontrol system.
1. Worn, bentor loose blade.
2. Mower deck not level.
3. Buildup of grass, leaves, and trash under mower,
4. Bent blade mandrel.
5. Clogged mower deck vent holes from buildup of
grass, leaves, and trash around mandrals,
t. Obstruction in clutch mechanism.
2. Worn!damaged mower drive belt.
3. Frozen idler pulley,
4. Frozen blade mandrel
1. Engine speed too slow.
2. Travel speed too fast.
3. Wet grass.
4. Mower deck not level.
5. Lowluneven tireair pressure.
6. Worn, bent or loose blade.
7. Buildup of grass, leaves and trash under mower.
8. Mower drive belt worn.
9. Blades improperly installed.
10. Improper blades used,
11. Clogged mower deck vent holes from buildup of
grass, leaves, and trash around mandrels.
1. Switch is"OFF".
2. Bulb(s) burned out.
3. Faulty light switch.
4. Loose or damaged wlr_ng.
5. Blown fuse.
1. Bad battery ceil(s).
2. Poor cable connections.
3. Faulty regulator (if so equipped).
4. Faulty alternator.
t.
CORRECTION
1. Check wiring, switches and connections, if not
corrected, contact an authorized service cented
department.
1, Replace blade, _ghten blade bolt.
2, Level mower deck.
3. Clean underside ol mower housing.
4. Replace blade mandrel.
5. Clean around mandrels to open vent holes.
1. Remove obstruction.
2. Replace mower drive belt.
3. Replace idler pulley.
4. Replace blade mandrel.
1. Place throttle controi in"FAST" position.
2. Shift to slower speed.
3. Allow grass to dry before mowing.
4, Level mower deck.
5. Check tires for proper air pressure.
8, Replace/sharpen blade. Tighten blade bolt.
7. Clean underside of mower housing.
8. Replace mower ddve belt.
9. Reinstall blades sharp edge down.
10, Replace with blades listed in t_is manual.
11. Clean around mandrels to open vent holes.
1. Turn switch "ON",
2, Replace bulb(s).
3. Check/top{ace light switch.
4. Check wiring and connections.
5. Replace fuse.
1_ Replace battery.
2. Check/clean all connections.
3. Replace regulator.
4r RepLace alternator.
Move throttle control to "SLOW" position and a!low
to idle for 30 seconds before stopping engine.
i_, ,.... i H i i
Engine throttle control not set at "SLOW'_ 1.
positionfor 30 seconds before stopping engine.
I]11 I]rL i i_1 , i
26
Loading ...
Loading ...
Loading ...