Loading ...
Loading ...
Loading ...
SERVICE AND ADJUSTMENTS
TO REPLACE MOWER BLADE DRIVE BELT
(See Fig. 20)
The mower blade drive belt may be replaced without
tools. Park the tractor on level surface. Engage parking
brake.
BELT REMOVAL -
= Place attachment clutch in "DISENGAGED" position.
o Move attachment lift lever forward to lower mower to
its lowest position.
,, Roll belt off engine pulley.
• Disconnect R.H. suspension arm from rear deck
bracket by removing retainer spring.
_o Work belt off both mandrel pulleys and idler pulleys.
= Pull belt away from mower.
BELT INSTALLATION -
• tnstatt new belt in reverse order of remora!.
• Make sure belt is in all pulley grooves and inside all
belt'guides,
WITH PARKING BRAKE "ENGAGED"
JAM NU_
OPERATING
ARM
FIG, 21
MANDREL R.H. SUSPENSION ARM ENGINE PULLEY
IDLER
PULLEY...
RETAINER
SPRING
/
MANDREL
PULLEY
FIG. 20
TO ADJUST BRAKE (See Fig. 21)
Your tractor is equipped with an adjustable brake system
which is mounted on the right side of the transaxle.
Iftractor requires more than six (6) feet stopping distance
at high speed in highest gear, then brake must be adjust-
ed.
°
@
o
Depress clutch/brake pedal and engage parking
brake.
Measure distance between brake operating arm and
nut "A" on brake rod.
If distance is other than 1-1/2", loosen jam nut and
turn nut "A" unti! distancebecomes 1-1/2". Retighten
jam nut against nut "A".
Road test tractor for proper stopping distance as stat-
ed above. Readjust if necessary. If stopping dis-
tance is still greater than six (6) feet in highest gear,
further maintenance is necessary. Contact your
nearest authorized service Center.
TO REPLACE MOTION DRIVE BELT
(See Fig. 22)
Parkthe tractoron level surface. Engage parking brake.
Forassistance, there isa beit installationguide decal on
bottom side of leftfootrest.
, Remove mower (See 'q'O REMOVE MOWER" inthis
section ofthis manual.)
- Remove belt from stationary idlerand clutchingidler.
• Pull belt slack toward rear of tractor. Remove belt
upwards from transaxle pulley by deflecting belt
keepers.
• Pull belt toward front of tractor and remove down-
wards from around engine pulley.
• tnstafl new belt by reversing above procedure.
ENGINE"--,--
PULLEY
CLUTCHING "----
IDLER
STATIONARY
IDLER
TRANSAXLE,.._
PULLEY
FIG. 22
2O
Loading ...
Loading ...
Loading ...