Loading ...
Loading ...
Loading ...
SERVICE AND ADJUSTMENTS
TO REPLACE HEADLIGHT BULB
• Raise hood.
• Pull bulb holder out of the hole in the backside of the
grill.
° Replace bulb in holder and push bulb holder secure-
ly back into the hole in the backside of the griiI.
° Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting.
° Check wiring. See electrical wiring diagram in Repair
Parts section.
TO REPLACE FUSE
Replace with 30 amp automotive-type p_ug-infuse. The
fuse holder is located behind the dash.
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 27)
= Raise hood.
• Unsnap headlight wire connector.
- Stand in front of tractor. Grasp hood at sides, tilt
toward engine and lift off of tractor.
• To replace, reverse above procedure.
HOOD
HEADLIGHT
WIRE
CONNECTOR
FIG. 27
ENGINE
TO ADJUST THROTTLE CONTROL CABLE
(See Fig. 28)
The throttle control has been preset at the factory and ad-
justment should not be necessary. Check adjustment as
described below before looseningcable. If adjustment is
necessary, proceed as follows:
• With engine not running, move throttle control lever
from stow to choke position. Slowly move lever from
choke to fast position.
, Check that holes "A" in governor control lever and
hole in governor plate line-up, tf holes "A" are not
aligned, loosen clamp screw and move throttle cable
until holes are aligned. Tighten clamp screw secure-
ly.
GOVERNOR GOVERNOR
CONTROL LEVER CONTROL PLATE
\
HOLES "A" CLAMP THROTTLE
SCREW CABLE
FIG. 28
TO ADJUST CARBURETOR
The carburetor has been preset at the factory and adjust-
ment should not be necessary. However, minor adjust-
ment may be required to compensate for differences in
fuel, temperature, altitude or load. If the carburetor does
need adjustment, see engine manual.
|MPORTANT: NEVER TAMPER WITH THE ENGINE GOVER-
NOR, WHICH IS FACTORY SET FOR PROPER ENGINE
SPEED. OVERSPEEDING THE ENGINE ABOVE THE FAC-
TORY HIGH SPEED SETTING CAN BE DANGEROUS. IF
YOU THINKTHE ENGINE-GOVERNED HIGH SPEED NEEDS
ADJUSTING, CONTACT YOUR NEAREST AUTHORIZED
SERVICE CENTER/DEPARTMENT, WHICH HAS PROPER
EQUIPMENT AND EXPERIENCE TO MAKE ANY NECES-
SARY ADJUSTM ENTS.
23
Loading ...
Loading ...
Loading ...