Loading ...
Loading ...
Loading ...
WINDROWER OPERATION
169304 49 Rev. C
6.3.5 Engine Operation
6.3.5.1 Starting
DANGER
• Avoid possible injury or death from a
runaway machine.
• Do not start engine by shorting across
starter terminals. Machine will start in
gear and move if normal starting circuitry
is bypassed.
• This machine has safety devices which
prevent the engine from starting. The
ground speed lever is in N-DETENT, the
steering wheel is locked in the neutral
position, and the header drive switch is
in the OFF position. Under no
circumstances are these circuits to be
deliberately rewired or misadjusted so
that the engine can be started with
controls out of neutral.
• Never start engine by shorting across
starter terminals. Machine will start with
drive engaged and move if normal
starting circuitry is bypassed.
• Never try to start engine with someone
under or near machine.
• Start engine only from operator's seat
with controls in neutral. NEVER start
engine while standing on ground.
Machine will start in gear and move if
normal starting circuitry is bypassed.
• Before starting engine, be sure there is
plenty of ventilation to avoid
asphyxiation.
IMPORTANT
Do not tow machine to start engine.
Damage to hydrostatic drives will result.
WARNING
Before starting engine, securely fasten your
seat belt and ensure trainer’s seat belt is
fastened if occupied. The seat belt can help
insure your safety if it is used and
maintained.
a. Move GSL (A) into N-DETENT.
b. Turn steering wheel until it locks.
c. Fasten seat belt.
d. Push header drive switch (B) to off.
e. Normal Start - engine temperature above 60°F
(16°C):
1. Set throttle (C) to start position – fully back.
IMPORTANT
The machine gauges and instruments
provide important information about
machine operation and condition.
Familiarize yourself with the gauges and
monitor them carefully during start-up
operation. Refer to Section 5.15, Engine
Controls/Gauges.
2. Turn ignition key (D) to RUN position.
CAUTION
Be sure the area is clear of other persons,
pets etc. before proceeding.
3. Single loud tone sounds, engine warning
lights illuminate and CDM displays HDR
DISENGAGED or HEADER ENGAGED and
IN PARK.
4. Turn ignition key to START position until
engine starts and then release key. Tone
ceases and warning lights go out. CDM
displays programmed header data for 5
seconds if attached and then returns to
previous display.
(continued next page)
D
A
B
C
START
RUN
OFF
Loading ...
Loading ...
Loading ...